Netgear WG302v2 WG302v2 Reference Manual - Page 88

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual Viewing General Information Table C-4 describes the commands you use to view some of the information that you see on the General page of the Web UI. Table C-4 General Information Task Command Access Point Information View Access Point Name get host id View the MAC Address for the Access Point get interface brvlan1 mac View the Country/Region get system country View the Firmware Version for the Access Point View the Access Point Mode get system version get interface brvlan1 type View the Untagged VLAN ID get untagged-vlan Current IP Settings View the IP Address get interface brvlan1 View the Subnet Mask get interface brvlan1 View the Default Gateway IP address View the DHCP Client status get ip-route gateway get management dhcp-client status Current Wireless Settings View the Operating Mode get radio all mode View the Channel / Frequency get radio all channel View whether Rogue AP Detection is enabled get radio all ap-detection View information about the Security Profiles get vap all detail The commands in the following table do not correspond to a specific Web page, but they can be C-6 Command Line Reference v1.0, May 2006