Netgear WNHD3004 WNHD3004 User Manual - Page 17
Setting Up Two WNHD3004 Units, Adding an Additional WNHD3004 to Your Network Later
View all Netgear WNHD3004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3DHD Home Theater Adapter WNHD3004 User Manual Setting Up Two WNHD3004 Units You can set up multiple WNHD3004 units, for example if you purchase them in the same package. Follow the instructions below. AP Mode Internet Router/gateway WNHD3004 Bridge Mode Gaming console WNHD3004 Digital Media Adapter Figure 2-4 Setting Up Two WNHD3004 Units at Once Follow these steps to set up two WNHD3004 devices. 1. Connect the Ethernet cable from a LAN port in the router or gateway to either LAN port on one home theater adapter. 2. Place the other home theater adapter near the media player, game console, or switch and connect it with an Ethernet cable. 3. To complete installation, connect power adapters to the Wireless-N Bridge(s). Allow a few minutes for your devices to connect to the Internet. Adding an Additional WNHD3004 to Your Network Later Home theater adapters, if purchased as a kit, are pre-configured to securely connect to each other automatically, according to the instructions above. To add another WNHD3004, simply use the WPS (Wi-Fi Protected Setup) push button. 1. Make sure the WNHD3004 you are adding is set to Auto or Bridge mode but not set to AP mode, and place it near the devices you will connect to it. Setting Up Your Wireless Network 2-5 v1.0, November 2010