Netgear XM128 QIG - Quick Install Guide - Page 92
Modem Reset, Using The Embedded Protocol Analyzer
View all Netgear XM128 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Reference Guide for the Model XM128 ISDN Digital Modem Dialed digits detected, please hang-up the handset....!! On-hook action is detected, (Hook Interrupt)........ OK Listen to the RING and then pick up phone set #2 ....!! Off-hook action is detected, (Hook Interrupt) ....... OK Listen to the dial tone and then dial 1234567890*# in quence.!! 1234567890*# Dialed digits detected, please hang-up the handset ..!! On-hook action is detected, (Hook Interrupt) ........ OK Listen to the prompt signal of the Internal Speaker and then press the button switch.......!! Button switch is pushed (Button Interrupt OK Modem Reset If you have modified the setting of the Model XM128 modem and cannot get it back because the unit is locking up, or you just want to reset it back to the factory default state, the following reset procedure helps you to reset the modem back to the factory default state. To reset the Model XM128 modem back to the factory default state, follow these steps: 1. Hold the DATA/VOICE button down while turning the unit on. Continue holding the switch down for 3 seconds after the power switch is turned on. 2. Release the switch. The Model XM128 modem resets itself back to the factory setting and runs a continuous loopback self-test. If the modem is connected to a terminal, printable characters show on the terminal screen. 3. Turn power to the modem off and then back on again. Using The Embedded Protocol Analyzer This section describes how to set up the embedded protocol analyzer (EPA) and capture and analyze the protocol data. 10-4 Troubleshooting