Nikon COOLPIX AW100 Reference Manual - Page 227
Troubleshooting, Power, Display and Settings Issues - release date
View all Nikon COOLPIX AW100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 227 highlights
Troubleshooting If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative. Refer to the page numbers in the right-most column for more information. • See "Error Messages" (E88) for more information. Power, Display and Settings Issues Problem Camera turns off without warning. Cause/Solution A • Battery is exhausted. 22 • Camera has turned off automatically by auto off to save 23 power. • Inside of the camera has become hot. Leave the camera - off until the inside of the camera has cooled. • At low temperatures, the camera and the battery may not F4 function normally. Monitor is blank. • Camera is off. 23 • Battery is exhausted. 22 • Standby mode for saving power: press the power switch, 23 the shutter-release button, A button, c button, or b (e movie-record) button. • Camera and computer are connected via USB cable. 73 • Camera and TV are connected via A/V cable or HDMI 73 cable. Monitor is hard to • Adjust monitor brightness. 94 see. • Monitor is dirty. Clean monitor. F2 Date and time of recording are not correct. • If the camera clock has not been set ("Date not set" 24, 94 indicator blinks during shooting), still pictures have a time stamp of "00/00/0000 00:00"; and movies are dated "01/ 01/2011 00:00." Set the correct date and time using Time zone and date in the setup menu. • The camera clock is not as accurate as a normal clock, 94 such as watches. Check camera clock regularly against more accurate timepieces and reset as required. No information displayed in monitor. Hide info is selected for Photo info under Monitor settings in the setup menu. Print date not available. Time zone and date in the setup menu has not been set. Date not • A shooting mode that does not support print date is appearing on selected. pictures even • Another function that is set now is restricting the print when Print date is date. enabled. • The date cannot be imprinted onto a movie. 94 24, 94 94 63 - Camera settings reset. Clock battery is exhausted; all settings were restored to their default values. 25 F13 Technical Notes and Index