Oki GL408e GL408e/GL412e User's Guide - Page 107

MENU Label But Size 560K Bytes* Host Form Length Enable* Left Position 0 dots* Top Position 0 dots/inch* Resolution Mode Full* Vertical Adjust Enable* Vertical Density 207 dpi* IS Label Fmt List Format* Unit 4: Printer Configuration ZGL EMULATION MODE (TABLE 4-11) DESCRIPTION Label Buffer Size. This option allows the label buffer size to be set. The buffer is used to store the data from ^XA up to ^XZ for command processing. The maximum buffer size cannot exceed the amount of available memory in the system. If a menu value greater than the amount of memory available is selected, the menu value will be set to the amount available. To increase the amount of available memory, increase the Glob Mem Adjust setting in the Printer control menu. The new buffer size only takes effect upon powering on, so perform a Save Config for the new setting and select that configuration as the Power-Up. The allowable range is 160 to 3600 Kbytes, and the factory default is 560 Kbytes. Determines the method of setting the Label Length. • Enable - factory default. Label length will be determined by the ^LL command if it is present. If the ^LL command is not present, it will be based on the Label Length value in the Quick Setup or Media Control menu. • Ignore - label length as determined by the ^LL command is ignored. • Disable - label length will be determined by the Label Length value in the Quick Setup or Media Control menu. The ^LS command specifies a horizontal offset to be added to all label element positions. The Left Position option displays the value specified by the ^LS command and provides an alternative method for specifying the horizontal offset. The factory default is 0 dots. The valueof this option specifies a vertical offset to be added to all label element posiotns in dots per inch. For example, if the value is 3 and the current form length is 6 inches, then 18 dots will be added to the element's vertical position. The allowable range is -100 to +100 dots/inch, and the factory default is 0 dots/inch. The ^JM command determines the apparent print resolution of the printed label. • Full - factory default. The output is printed normally. The Resolution mode option displays and selects the current setting associated wit the ^JM command. • Half - if selected by the ^JM command, the printed output of a 300 dpi printer matches that printed by a 150 dpi printer (half resolution). This essentually doubles the size of the label image, including label dimensions. Allows the vertical adjustment feature to be enabled or disabled. • Disable - factory default. Vertical density adjustment will not take place. • Enable - is active and will use the Vertical Density value selected. If Vertical Adjust is enabled, this option allows to fine tune the vertical print density (in the paper motion direction) on printers with 203 or 300 dpi print heads. The result is that the vertical posiiton and height will be changed accordingly. Selecting a greater vertical density value causes the image to compress or expand vertically on the label. • 203 DPI - the allowable range is 201 to 220 dpi, and the factory default is 207 dpi. • 300 DPI - the allowable range is 301 to 330 dpi, and the factory default is 300 dpi. This command saves the printed label image by name for later recall as part of a label definition and determines the internal format to be used. The storage location is determined by the option selected in the Storage Select menu. • List Format - factory default. Used for most applications due to its greater efficiency of data process. • Bitmap Format - used in applications that frequently recall the saved label image. Results in greater print speed. GL408-412e Operator Manual 4-71 PN: 9001163A