Oki GL408e GL408e/GL412e User's Guide - Page 143
Adjustment Procedures, Label Sensor Positioning
View all Oki GL408e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Unit 6: Maintenance ADJUSTMENT PROCEDURES This chapter covers all of the printer and printer accessory adjustments. These adjustments include mechanical adjustments required following the replacement of components and assemblies, in addition to, the operational adjustments required following a job change. LABEL SENSOR POSITIONING The label sensor assembly provides a mounting apparatus for the eye-mark, gap, and paper-end sensors. Position adjustment of the label sensor is not required when using standard label media. When non-standard media is used, place a section of the media on the media ramp oriented as if loaded for printing. Manually grasp the sensor assembly and move it laterally so that the sensor indicators embossed in its side are aligned with the reference marks on the media. 1 Open the right housing cover to access print assembly. 2 Find label sensor adjustment handle (Figure 6-4) located between the upper and lower print assemblies. 3 Manually move the adjustment handle to the left or right as required to properly position the label sensor. NOTE: There are two markers on the front face of the media stabilizer. The marker closes to the printer's center frame references the location of the eye-mark sensor, the one furthest out references the gap sensor Adjust according to the type of media to be used. NOTE: Sensor positioning may also be achieved by measuring from the printer's center frame outward to the specified distance for sensor/reference mark alignment. Refer to Figure 9-3 in the Appendix unit of this manual for applicable dimensions. 4 Test print a label to determine if the label sensor is properly aligned. Label Sensor Sensor Markers Media Stabilizer Adjustment Handle GL408-412e Operator Manual Figure 6-4, Label Sensor Positioning 6-6 PN: 9001163A