Oki GL408e GL408e/GL412e User's Guide - Page 91
Enable, Disable, minutes, minutes, Auto Select, Half Duplex, Full Duplex, Half Duplex, Full Duplex,
View all Oki GL408e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Unit 4: Printer Configuration LOCAL AREA NETWORK (LAN) INTERFACE MODE (TABLE 4-8) MENU DESCRIPTION Is a transitional screen that allows entry into the Net BIOS Protocol menu. ETHERNET SETTING NetBIOS Protocol NetBIOS Protocol Enable* ASCII Data Port 1024* Allows determination of if the NIC will recognize the NetBIOS protocol. • Enable - factory default. Will recognize. • Disable - will not recognize. This options allows for the port number to be set for ASCII print jobs. The data port number must match the host computer setting. The allowable range is 0 to 65535, and the factory default is 9100. Keep Alive Timer 3 minutes* Determines the amount of time that the tcp connection will remain connected after the print job has terminated. The allowable range is 2 to 10 minutes, and the factory default is 3 minutes. Ethernet Speed Auto Select* Job Control Standard* Offline Process Disable* ETHERNET ADDRESS IP Address Subnet Mask Gateway Address MAC Address DHCP This menu appears only if a 10/100Base-t Network Interface Card (NIC) is installed. There are five different speed modes to allow compatibility with different systmes and networks. • Auto Select - factory default. Tells the 10/100Base-T NIC to perform an automatic detection scheme and configure itself to be one of the other allowable options. • 10 Half Duplex - communicates at 10 megabytes per second using half duplex. • 10 Full Duplex - communicates at 10 megabytes per second using full duplex. • 100 Half Duplex - communicates at 100 megabytes per second using half duplex. • 100 Full Duplex - communicates at 100 megabytes per second using full duplex. Determines how the printer and/or NIC card respond when a job has been completed. The definition of a complete job is also determined by this setting. • Standard - factory default. The NIC card responds to the host that the job is complete when the entire print job has been accepted by the printer. • Enhanced - the NIC card responds to the host that the job is complete when the entire job has not only been accepted by the printer, but also completely printed. • Off - without synchronization between the NIC and the printer. The NIC card is simply a pass-trough and the printer tells the host when the job is complete. Determines whether the printer processes incoming data when it is in an offline state. • Disable - factory default. The printer does not process data while offline. • Enable - continues to process (but not print) the current network/parallel job while the printer is offline until in a buffer-near-full state. Is the menu selection screen for the Ethernet Address option of the INTERFACES mode. Its menu options are explained in the following five menu screen descriptions. GL408-412e Operator Manual 4-55 PN: 9001163A