Oki GL408e GL408e/GL412e User's Guide - Page 126
Error Signal Troubleshooting, Error Signals - firmware
View all Oki GL408e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Unit 5: Troubleshooting ERROR SIGNAL TROUBLESHOOTING ERROR SIGNALS DISPLAY B10 ERROR: NO DRAM DETECTED Cycle Power EXPLANATION The printer could not find any DRAM. SOLUTION Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative. B11 ERROR: RAM TEST FAILED Cycle Power The printer found a defactive memory location. Power off the printer for 15 seconds, then power on again. If the problem persists, contact an authorized customer service representative. B12 ERROR: PROGRAM MISSING Repeat Download The printer cannot the data controller program or Power off the printer for 15 seconds, then power the validation checksum is corrupt. on again. If the problem persists, contact an authorized customer service representative. B22 ERROR: DECOMPRESS SIZE Repeat Download Problem when downloading. Cycle power. If the problem persists, repeat download. B23 ERROR: DECOMPRESS CKSUM Repeat Download Problem when downloading. Cycle power. If the problem persists, repeat download. CALIBRATION FAIL See User Manual Calibration values derived from Manual Perform a Run Manual Cal (run manual Calibrate were not acceptable. calibration) again. DOWNLOADER ERROR BEYOND 8MB EFC Repeat Download Printer contains an 8MB EFC and the firmware Contact an authorized service representative. attempted to access beyond its limit. DOWNLOADER ERROR BEYOND 16MB EFC Repeat Download Printer contains an 16MB EFC and the firmware Contact an authorized service representative. attempted to access beyond its limit. GL408-412e Operator Manual 5-2 PN: 9001163A