Oki GL408e GL408e/GL412e User's Guide - Page 22
Interface Selection, Rs232c High-speed Serial Interface - driver
View all Oki GL408e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Unit 3: Installation INTERFACE SELECTION This unit presents the printer interface types and their specifications. These specifications include detailed information to assist in the selection of the most appropriate method for the printer to interface with the host. The five acceptable interface methods are: • RS232C High-Speed Serial • IEEE1284 Parallel • Universal Serial Bus (USB) • Local Area network (LAN) Ethernet • 802.11g Wireless Following the selection of the desired interface, proceed to the next unit for instructions on how to configure the printer for that interface type. WARNING: NEVER CONNECT OR DISCONNECT INTERFACE CABLES (OR USE A SWITCH BOX) WITH POWER APPLIED TO EITHER THE HOST OR THE PRINTER. THIS MAY CAUSE DAMAGE TO THE INTERFACE CIRCUITRY IN THE PRINTER/HOST AND IS NOT COVERED BY WARRANTY. RS232C HIGH-SPEED SERIAL INTERFACE Asynchronous ASCII Data Transmission Rate Transmission Form Data Length Stop Bit Parity Bit Codes Used Control Codes Connector (Printer Side) Cable Connector Cable Length Signal Levels Protocol INTERFACE SPECIFICATIONS Half-duplex communication Bi-Directional Communication 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 bps Start, b1, b2, b3, b4, b5, b6, b7, b8, Stop (b8 will be omitted if using 7 bit oriented) 7 or 8 bit (selectable) 1 or 2 bit (selectable) ODD, EVEN, NONE (selectable) ASC II Character Codes: 7 bits, Graphics: 8 bits STX (02H), ETX (03H), ACK (06H), NAK (15H) DB-9 Male (equivalent), 9-pin Serial Interface (PCI) DB-9 Female (equivalent), 9-pin Serial Interface (PCI) 5 meters or less. High = +5V to +12V, Low = -5V to -12V Ready/Busy, X-On/X-Off, Protocol for Driver, Status2, Status3, Status4, Status5 GL408-412e Operator Manual Figure 3-5, Serial Connector Pin Assignments 3-8 PN: 9001163A