Oki MC780f MC770/780 User Guide - Advanced - Page 194
If the screen below appears, place another, original on the original glass and press
![]() |
View all Oki MC780f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
USEFUL FUNCTIONS 4 Make the settings required for the selected scan function, and then press [OK]. • The required settings vary depending on the selected 1 scan function. For instructions on how to perform settings for each scan function, see the following sections: Basic Guide For instructions on how to scan your documents with Scan to e-Filing, refer to the e-Filing Guide. • Pressing [OK] on the screen for each scan function takes you back to the basic scan menu with the 2 selected function button marked with an orange line. 5 On the SCAN menu, select the second scan function that you want to use, and repeat step 4. 7 If the screen below appears, place another original on the original glass and press [SCAN] or the [START] button to continue scanning. To finish the job, press [JOB FINISH], followed by the [RESET] button. 3 6 4 On the SCAN menu, press [SCAN]. 5 Note 6 • You can set 2 scan functions at one time. Selecting 3 scan functions at one time is not allowed. • The WS Scan function cannot be selected with other scan functions. Memo • To clear the scan functions, select one and press 7 [RESET]. The screen on the touch panel returns to the basic scan menu and the selected button is cleared. • The above screen is not displayed under the following conditions: - You scan the original from the Reversing Automatic Document Feeder without pressing [CONTINUE] to scan additional originals. - A scan preview is displayed. • To cancel the operation, press [JOB CANCEL]. • To change the scan settings, press [SCAN SETTING]. P.181 "Changing Scan Settings" Note • When the equipment has scanned more than 1000 pages in a job, the "The number of originals exceeds the limits. Will you save stored originals?" message appears. If you want to save the scans, press [YES]. • When the temporary workspace is full on the equipment's hard disk, a message appears and the job is canceled. The available workspace can be viewed on the TopAccess [Device] tab. • If the number of jobs waiting to store scans in the equipment's hard disk exceeds 20, a message appears to indicate that the equipment's memory is full. In this case, wait a while until memory becomes available again or delete unnecessary jobs from [JOB STATUS]. Basic Guide - 194 -
![](/manual_guide/products/oki-data-mc770-mc770780-user-guide-advanced-7299944/194.png)