Panasonic KX-P3696 Operating Instructions - Page 31
dnieS, Bu!Sfl
View all Panasonic KX-P3696 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Initial Setup Mode Menu Item Setting Description INTERFACE [This setting is effective only when the optional KX-PS14, RS-232C serial interface board is installed.] INTERFACE DATA LENGTH BAUD RATE" PARALLEL* SERIAL 8 BITS* 7 BITS 150 BPS 300 BPS 600 BPS 1200 BPS 2400 BPS 4800 BPS 9600 BPS* Selects the desired interface parallel or serial. Selects Data Length 8 bits or 7 bits. Selects the desired baud rate. PARITY" NONE' IGNORE ODD EVEN Selects the desired parity. PROTOCOL" SDT" DTR` XON/XOFF RBC 128' RBC 512 Selects the desired protocol DTR or XON/XOFF. C) Selects the remaining buffer capacity (R.B.C.) 128 byte or 512 byte to 13 suspend data transfer (S.D.T.) (X/OFF). ta) RDT" SDT + 128* SDT + 256 Selects the remaining buffer capacity (R.B.C.) 128 byte or 256 byte to resume data transfer (R.D.T.) (X/ON). T.O.F. SETTING (Top of Form Setting) TRACTOR FRICTION 0.00" to 5.00" (24/721 (0.00 cm to 12.70 cm) 0.00" to 5.00" (24/72") (0.00 cm to 12.70 cm) The number increases or decreases by 1/ 72" (about 0.35 mm). The number increases or decreases by 1/ 72" (about 0.35 mm). CUT SHEET FEEDER 0.00" to 5.00" (24/ 72-) (0.00 cm to 12.70 cm) The number increases or decreases by V72" (about 0.35 mm). [This setting is operational when using the optional Cut Sheet Feeder (KX-P38).] denotes setting when shipped from factory. " displayed only when SERIAL is selected in INTERFACE. )1Sia dnieS Mil Bu!Sfl 31