Pfaff creative 1467 Owner's Manual - Page 177
lifter, pushing
View all Pfaff creative 1467 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
Darning with straight stitch Feed dog: Presser bar lifter: Sewing thread: lowered in darning position embroidery and darning thread Darning position (Fig. 1): Lower presser bar lifter 'A", at the same time pushing it back slightly until it enters notch "B" at the bottom of its slot. Attaching the darning foot (Fig. 2): Raise the needle. Push lever "E" towards the back and hold it there. Insert the pin of the foot in hole "C" and insert the foot so that it rests against its stop. When you do so, guide fork "G" fits around the presser bar. Release clamp "E", which then moves down onto retaining screw "F". Tighten screw 'D" Draw up the bobbin thread. Hold both threads until the machine has made a few stitches. First sew a few stitches in the unworn area of the fabric. Then stitch over the damaged spot from one side to the other in serpentine fashion, placing the lines of stitching close together (Fig. 3). When the damaged spot has been covered completely, turn the work through 90' and darn at right angles to the preceding row of stitches (see Fig. 4). You determine the length of the darning stitches by the rate at which you move the fabric back and forth, 2 -' r r- -, I 3 4