Pfaff creative 1467 Owner's Manual - Page 192
Push slide
View all Pfaff creative 1467 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 192 highlights
Cause: Remedy: 5. Machine feeds irregularly or not at all Lint has accumulated between tooth rows of feed dog. Feed dog lowered. (Slide control is at right). Remove needle plate and remove lint with a soft brush. Push slide control to the left. 6. Machine runs with difficulty Thread ends in hook raceway. Remove thread ends and put one drop of oil into hook raceway. 7. Electronic bobbin thread monitor does not work Thread ends and dirt have collected in the free arm cover over the sensor, in the hook raceway, in the bobbin case, behind the hook and on the second sen sor to the right behind the hook. Remove thread ends and dirt. Special care should be taken in the area round the second sensor. 8. Machine does not sew the program entered Switch the machine off, wait about 30 seconds, then switch it on again. Again enter the desired program. 9. Machine can no longer be programmed If you find that it is not possible to program the computer although it is not filled up, the machine must be switched off and on again after about 30 seconds, The MEM-memory is now cleared. The required program sequences must be input again. 10. The sewing lamp lights up, but the machine does not run Fuse is defective. Insert new fuse. Important: Before exchanging either sewing foot or needle, switch off master switch 107. Never run a threaded machine unless there is a piece of fabric under the sewing foot. If you have to leave the machine, even for a short while, be sure to switch off the master switch, This is particularly important when children are around. ii,