Ricoh 5510L Operating Instructions - Page 63
Programming - service mode
View all Ricoh 5510L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
3. Programming Own Name/Fax Header/Own Fax Number Make sure that all necessary settings are made before connecting your machine to the telephone line. ❖ Own Name This should be your name or company name, in 20 characters or less. During communication, if the other party's fax machine supports Own Name, this replaces the Own Fax Number that follows. This name will appear on the display of the other party's fax machine, and the name programmed on that machine will appear on yours. Limitation ❒ The programmed name will not be used unless the other party has a machine of the same make that supports the Own Name function. ❖ Fax Header This is ordinarily your name or company name. Your fax header can be up to 32 characters long, and is printed on the header of every page you send. You can program Fax Header1 or Fax Header2. When you send originals using Quick Dial or Speed Dial, you can select which Fax Header will be printed on the message received by the other party. ❖ Own Fax Number (Required by international law) This is your fax machine's phone number that must include country and area codes using 20 characters or less. During any communication, your Own Fax Number appears on their display. (Conversely their Own Fax Number appears on your display.) Note ❒ In some areas, the Own Fax Number is preprogrammed by your service representative, and cannot be re-programmed by the user. Important ❒ When sending a fax, your Own Fax Number is required by international law. You cannot legally connect a fax machine to the telephone system if the Own Fax Number is not programmed. ❒ You can confirm the Own Name, Fax Header, and Own Fax Number settings in the User Parameters List. See p.189 "Printing the User Parameter List", . Note ❒ Make sure that the machine is in standby mode before performing the following procedures. ❒ When the Optional Extra G3 Interface Unit is installed, register using the "G3-2 Analog Line". See p.189 "G3 Analog Line", . 55