Samsung CLP 660ND User Manual (ENGLISH) - Page 24
Getting Started, Setting up the hardware - toner
UPC - 635753720570
View all Samsung CLP 660ND manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
3 Getting Started This chapter gives you step-by-step instructions for setting up the machine. This chapter includes: • Setting up the hardware • Setting up the network • Installing the software • Printer's basic settings Setting up the hardware This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps. 1 Select a stable location. Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays. The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table. Place the machine on a flat and stable surface, not letting it tilt more than 2 mm (0.08 inches). Otherwise, it may affect the print quality. 2 Unpack the machine and check all the enclosed items. 3 Remove the tape holding the machine tightly. 4 Install all four of the toner cartridges. 5 Load paper. (See "Loading paper" on page 4.4.) 6 Make sure that all the cables are connected to the machine. 7 Turn the machine on. Caution When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality. Setting up the network You need to set up the network protocols on the machine to use it as your network printer. You can set up the basic network settings with the machine's control panel. Note • If you want to use the USB cable, connect between a computer and your machine. Then, refer to the software installation in Software section. Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See page 3.4 for more information. 3.1