Sanyo PLC-HF15000L RS232 Expand - Page 57
CF_PJPINCODE Command, 9.51 CF_SHUTRCPROT Command, 9.52 CF_SHUTKEYPROT Command, 9.53 CF_SHUTH
View all Sanyo PLC-HF15000L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
PLC-HF15000L Expand Serial Command Functional Specifications 8.9.50 CF_PJPINCODE Command Command "CF_PJPINCODE_%1" [CR] %1 "0000 - 9999 Directly specify PJ PIN code Enter PIN code to cancel PIN code lock (Available only in the normal Power ON status) PIN code can not be changed. (Only PIN code lock is canceled.) Details *When PIN code Lock is enabled: PIN code is matched Command is valid (Acceptable) PIN code is mismatched Command is invalid (Error code "102") PIN code is beyond %1 available range ----- Command is invalid (Error code "?") When PIN code lock is canceled: PIN code is within %1 range Command is valid (Acceptable) PIN code is out of %1 range Command is invalid (Error code is "?") This command is only valid when "PJ PIN code" dialog is displayed to enter PIN code after Power is ON and Countdown is completed. When PIN code lock is set to "On1", it needs to send this command every time the projector is turned on. Acceptable Response "000" [CR] Unacceptable "Error Code" [CR] 8.9.51 CF_SHUTRCPROT Command Command "CF_SHUTRCPROT_%1" [CR] %1 "ON Disable RC key from controlling Shutter (Protection On) "OFF Enable RC key to control Shutter (Protection Off) Details Set valid / invalid of RC use on Shutter control function (Valid only when in the normal Power ON status) Acceptable Response "000" [CR] Unacceptable "Error Code" [CR] 8.9.52 CF_SHUTKEYPROT Command Command "CF_SHUTKEYPROT_%1" [CR] %1 "ON" --------- Disable key on the side panel from controlling Shutter (Protection On) "OFF" -------- Enable key on the side panel to control Shutter (Protection Off) Details Set valid / invalid use of key on the top panel on Shutter control function. (Valid only when in the normal Power ON status) Acceptable Response "000" [CR] Unacceptable "Error Code" [CR] 8.9.53 CF_SHUTH Command Command "CF_SHUTH_%1" [CR] "005"-"480"----------Specify setting time directly %1 "UP Add 1 minute "DN Decrease 1 minute Details Set time of operating shutter management function. (Valid only when in the normal Power ON status) The status set by this command is stored in EEPROM and setting remains effective even after the power is turned to ALL OFF status. Acceptable Response "000" [CR] Unacceptable "Error Code" [CR] 57/105