Sharp NP-PH3501QL Installation Manual - NEC - Page 133
D terminal D-sub 15 pin, 3D_DISPLAY_REFER
![]() |
View all Sharp NP-PH3501QL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
3D terminal (D-sub 15 pin) This is used to connect a 3D image system to the projector. 7. Appendix Pin view of a female connector Pin No. Signal Name I/O Function 1 +12V PWR Supplies power (+12V) to the 3D image system 2 GNDC GND Ground 3 GNDC GND Ground 4 RS232_RX IN Data transmission from the 3D image system (1200 Baud, 8 bits, No Parity) 5 RS232_TX OUT Data transmission to the 3D image system (1200 Baud, 8 bits, No Parity) 6 CONN_3D_MODE+ OUT 3D mode status (+) (Connects to the collector of the output transistor of the photo coupler inside the projector) 7 CONN_SYNC+ OUT 3D L/R switching timing signal (+) (Connects to the collector of the output transistor of the photo coupler inside the projector) 8 3D_INPUT_REFERENCE+ IN 3D L/R timing signal (+) (Connects to the anode of the input diode of the photo coupler inside the projector) 9 +12V PWR Supplies power (+12V) to the 3D image system 10 3D_INPUT_REFERENCE− IN 3D L/R timing signal (-) (Connects to the cathode of the input diode of the photo coupler inside the projector) 11 3D_DISPLAY_REFERENCE+ IN 3D L/R display timing signal (+) (Connects to the anode of the input diode of the photo coupler inside the projector) 12 3D_DISPLAY_REFERENCE− IN 3D L/R display timing signal (-) (Connects to the cathode of the input diode of the photo coupler inside the projector) 13 CONN_3D_MODE− OUT 3D mode status (-) (Connects to the emitter of the output transistor of the photo coupler inside the projector) 14 CONN_SYNC− OUT 3D L/R switching timing signal (-) (Connects to the emitter of the output transistor of the photo coupler inside the projector) 15 N/C − Unused 107
![](/manual_guide/products/sharp-npph3501ql-installation-manual-nec-4309891/133.png)