Sharp NP-PH3501QL Installation Manual - NEC - Page 5
Power Supply, Do not do it, CAUTION
View all Sharp NP-PH3501QL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WARNING Do not do it 1. Do not use the projector with the supplied lens cap or equivalent while the projector is operating. This may cause the lens cap to heat up and deform or melt. 2. Do not place any objects, which are easily affected by heat, in front of the projector lens. Doing so could lead to the object melting from the heat that is emitted from the light output. It is possible to vertically set up this device at 360 degrees. Do not use the projector with it leaning to the left and right. This may result in a malfunction, however, portrait installation is possible. Please read the warnings concerning portrait orientation before setting the projector in portrait orientation. Important Information 3. Handle the power cable carefully. A damaged or frayed power cable can cause electric shock or fire. • Do not bend or tug the power cable excessively. • Do not place the power cable under the projector, or any heavy object. • Do not cover the power cable with other soft materials such as rugs. • Do not heat the power cable. 4. Placing the power cable and the signal cable closely to each other can cause beat noise. If this happens, keep the two separated so that beat noise is not generated. Beat noise is corruption of the picture often seen as a rolling band moving through the image. 5. Do not touch the projector during a thunder storm. Doing so can cause electrical shock or fire. 6. When installed on the ceiling, install the breaker in a location that is easy to reach by hand. CAUTION This equipment is designed to be used in the condition of the power cable connected to earth. If the power cable is not connected to the earth, it may cause electric shock. Please make sure the power cable is earthed properly. Power Supply 1. Consult your distributor for installing the power cable to the projector. DO NOT install the power cable by yourself.Doing so may cause a fire or electric shock. The projector is so designed that it operates with the power supply voltage described below. For C1 connection (When the AC power to the projector power supply and the light power supply is provided by a single cable) • AC 200V-240V single phase 50/60Hz For C2 connection (When the AC power to the projector power supply and the light power supply is provided by separate cables) • AC 200V-240V single phase 50/60Hz (projector power supply) • AC 200V-240V single phase 50/60Hz (light power supply) Ensure that your power supply fits this requirement before attempting to use your projector. 2. The power cable is not included with the projector. Ask your distributor for the power cable to select and purchase. Use a power cable that meets the standards and power supply voltage of the country where you are using the projector. Refer to "1-8. Connecting the Power Cable" (→ page 24) for details on connecting the power cable. iii