Sharp NP-PH3501QL Installation Manual - NEC - Page 45
AC Power Work Specifications, AC power supply equipment, AC power supply cable for the projector
![]() |
View all Sharp NP-PH3501QL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
AC Power Work Specifications 1. Before Setting Up Your Projector AC power supply equipment Do not use any voltage other than those shown below for the AC power supply connected to the projector. 200-240V AC, single phase, power, 50/60Hz AC power supply cable for the projector The projector is equipped with an IEC60320-C14 inlet to connect an AC power supply cable. Use an IEC60320-C13 compliant AC power cable connector and ensure that the connector meets the following current capacity specifications. Power supply voltage AC 200-240V Projector input current 4.9A Power cable current capacity 10A or higher Furthermore, use plugs, cables, and connectors that are suitable for the regulations of the country of installation, as shown in the following table. NOTE: • For users in North America Use a power cable no longer than 4.5m/14.76 ft according to National Electrical Code. • For UK only: In UK, a BS approved power cable with moulded plug has a black (10 Amps) fuse installed for use with this equip- ment. If a power cable is not supplied with this equipment, please contact your supplier. Plug Cable Germany CEE 7 Plug Connector Cable H05VV-F 3 x 1 mm2 Connector IEC60320 C13 USA NEMA 6-15P Plug Cable SJT 3 x AWG 16 Connector IEC60320 C13 19
![](/manual_guide/products/sharp-npph3501ql-installation-manual-nec-4309891/45.png)