Sony CDX-MP30 Operating Instructions (English, Español, Fran&cc - Page 24
Specifications, POWER OUTPUT AND TOTAL HARMONIC DISTORTION - car stereo
View all Sony CDX-MP30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION 23 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion. CD player section Signal-to-noise ratio Frequency response Wow and flutter 90 dB 10 - 20,000 Hz Below measurable limit Tuner section FM Tuning range 87.5 - 107.9 MHz Antenna terminal External antenna connector Intermediate frequency 10.7 MHz Usable sensitivity 11 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 65 dB (stereo), 68 dB (mono) Harmonic distortion at 1 kHz 0.7 % (stereo), 0.5 % (mono) Separation 33 dB at 1 kHz Frequency response 30 - 15,000 Hz AM Tuning range Antenna terminal Intermediate frequency Sensitivity 530 - 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 µV Power amplifier section Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 - 8 ohms Maximum power output 52 W × 4 (at 4 ohms) General Outputs Inputs Tone controls Power requirements Dimensions Mounting dimensions Mass Supplied accessories Optional accessories Optional equipment Power antenna relay control lead Telephone ATT control lead Bass ±10 dB at 20 Hz Treble ±10 dB at 20 kHz 12 V DC car battery (negative ground) Approx. 178 × 50 × 177 mm (7 1/8 × 2 × 7 in.) (w/h/d) Approx. 182 × 53 × 161 mm (7 1/4 × 2 1/8 × 6 3/8 in.) (w/h/d) Approx. 1.2 kg (2 lb 10 oz) Parts for installation and connections (1 set) Front panel case (1) Card remote commander RM-X115 Rotary commander RM-X4S BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2m) CD changer (10 discs) CDX-757MX, CDX-656 CD changer (6 discs) CDX-T70MX, CDX-T69 MD changer (6 discs) MDX-66XLP MG Memory Stick System-up Player MGS-X1 Source Selector XA-C30 Note This unit cannot be connected to a digital preamplifier or an equalizer. Design and specifications are subject to change without notice. 24