Sony ICD-TX50 Operating Instructions - Page 112
Messages List
View all Sony ICD-TX50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Table of Contents Index 112 Troubleshooting Messages List Follow the instructions below if a message appears in the display. Message Cause/Remedy HOLD... Slide HOLD Switch to Activate. All the button operations are disabled because the IC recorder is in the HOLD status to prevent unintentional operations. Slide the POWER•HOLD switch towards the center to release the IC recorder from the HOLD status ( p. 16). Low Battery Level You cannot format the memory or erase all the files in a folder because of insufficient battery power. Charge the battery ( p. 18). Low Battery The battery is exhausted. Charge the battery ( p. 18). Low Battery to Update You cannot update the firmware because of insufficient battery power. Charge the battery ( p. 18). microSD Card Error An error occurred while a microSD card was being inserted into the microSD card slot. Remove and try inserting it again. If this message persists, use a new microSD card. microSD Card Not Supported A microSD card that the IC recorder does not support is inserted. See "About compatible microSD cards" ( p. 33). Read Only microSD Card A read-only microSD card is inserted. A read-only microSD card cannot be used with the IC recorder. microSD Card Locked A write-protected microSD card is inserted. Release the lock. Memory Full The remaining memory capacity of the IC recorder is insufficient. Erase some files before recording. File Full When there are already the maximum number of files in the selected folder or the total number of files stored on the IC recorder has exceeded the maximum, you cannot record a new file. Erase some files before recording. Settings are Full You cannot rename a folder, since folders with the same folder name already exist. Please select a different folder name. Track Marks are Full You cannot set a track mark, since there are already the maximum number of track marks for a file. Cancel unwanted track marks ( p. 61). File Damaged You cannot play back or edit files, because the data of the selected file is damaged. Continued