Home » Sony Manuals » Audio Components » Sony STR-DA1800ES » Manual Viewer

Sony STR-DA1800ES Operating Instructions (Large File - 20.62 MB) - Page 125

Tuner, iPod/iPhone, USB device, The iPod/iPhone cannot be charged.

Add to My Manuals
Save this manual to your list of manuals

Page 125 highlights

Tuner The FM reception is poor. • Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antennas (aerial) as shown below. Outdoor FM antenna (aerial) Receiver Radio stations cannot be tuned in. • Check that the antennas (aerials) are connected securely. Adjust the antennas (aerials) and connect an external antenna (aerial), if necessary. • The signal strength of the stations is too weak with automatic tuning. Use direct tuning. • Make sure you set the tuning scale correctly (when tuning in AM stations with direct tuning) (page 63). • No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations is used). Preset the stations (page 64). • Press AMP, then press DISPLAY repeatedly on the remote control so that the frequency appears on the display panel. iPod/iPhone The sound is distorted. • Press MASTER VOL - on the remote control repeatedly. • Set the "EQ" setting of the iPod/iPhone to "Off" or "Flat". There is no sound from the iPod/ iPhone. • Disconnect the iPod/iPhone and connect the iPod/iPhone again. The iPod/iPhone cannot be charged. • Check that the receiver is turned on. • Make sure the iPod/iPhone is connected firmly. The iPod/iPhone cannot be operated. • Check that you have removed the protect case of the iPod/iPhone. • Depending on the contents of the iPod/ iPhone, it may take time to start playback. • Disconnect the iPod/iPhone and connect the iPod/iPhone again. • You are using an unsupported iPod/ iPhone. See "Compatible iPod/iPhone models" (page 56) for the supported device types. The ring volume of the iPhone does not change. • Adjust the ring volume using the controls on the iPhone. USB device Are you using a supported USB device? • If you connect an unsupported USB device, the following problems may occur. See "Compatible USB devices" (page 59) for the supported device types. - The USB device is not recognized. - File or folder names are not displayed on this receiver. - Playback is not possible. - The sound skips. - There is noise. - A distorted sound is output. Additional Information continued 125US

Section	Page
US	1
About This Manual	4
Supplied accessories	9
Description and location of parts	10
Getting started	19
Connections	22
1: Installing the speakers	22
2: Connecting the speakers	24
3: Connecting the TV	26
4a: Connecting the video equipment	28
4b: Connecting the audio equipment	37
5: Connecting the antennas (aerials)	38
6: Connecting to the network	39
Preparing the Receiver	41
Connecting the AC power cord (mains lead)	41
Turning on the receiver	41
Performing initial setup operations (clearing all memorized settings)	42
Setting the speakers	42
Using AUTO CALIBRATION	44
Configuring the network settings of the receiver	48
Guide to on-screen display operation	52
Basic Operations	54
Playing an input source equipment	54
Playing an iPod/iPhone	56
Playing a USB device	59
Recording using the receiver	61
Tuner Operations	62
Listening to FM/AM radio	62
Presetting FM/AM radio stations (Preset Tuning)	64
Enjoying Sound Effects	65
Selecting the sound field	65
Using the Sound Optimizer function	69
Resetting sound fields to the default settings	69
Using Network Features	70
About the network functions of the receiver	70
Setting up the server	70
Enjoying audio content stored on the server	74
Enjoying Sony Entertainment Network (SEN)	76
Using the PARTY STREAMING function	78
Streaming music from iTunes with AirPlay	80
Updating the software	81
Searching for an item using a keyword	83
Using Bluetooth Features	84
About the Bluetooth wireless technology	84
About the Bluetooth functions of the receiver	84
Listening to music of a Bluetooth device	85
“BRAVIA” Sync Features	87
What is “BRAVIA” Sync?	87
Preparing for the “BRAVIA” Sync	88
Playing back equipment with one-touch operation (One-Touch Play)	88
Enjoying the TV sound from the speakers connected to the receiver (System Audio Control)	89
Turning off the receiver with the TV (System Power-Off)	89
Enjoying optimum sound field for the selected scene (Scene Select)	90
Operating the receiver using the TV’s remote control (Home Theatre Control)	90
Enjoying the TV sound from the speakers connected to the receiver via HDMI OUT A jack (Audio Return Channel)	90
Switching the monitors that output the HDMI video signals	91
Other Operations	91
Switching between digital and analog audio (INPUT MODE)	91
Using other video/audio input jacks (Input Assign)	92
Using a bi-amplifier connection	94
Using multi-zone features	95
Adjusting Settings	98
Using the Settings menu	98
Speaker Settings	99
Surround Settings	101
EQ Settings	102
Audio Settings	102
HDMI Settings	103
Network Settings	104
Bluetooth Settings	107
System Settings	107
Operating without connecting to a TV	108
Using the Remote Control	113
Programming the remote control	113
Clearing the memory of the remote control	118
Additional Information	118
Precautions	118
Troubleshooting	120
Specifications	133
Index	136
FR	140
À propos de ce mode d’emploi	142
Accessoires fournis	147
Description et emplacement des pièces	148
Préparatifs	157
Raccordements	160
1 : Installation des enceintes	160
2 : Raccordement des enceintes	162
3 : Raccordement du téléviseur	164
4a : Raccordement des appareils vidéo	166
4b : Raccordement des appareils audio	175
5 : Raccordements des antennes	176
6 : Connexion au réseau	177
Préparation de l’ampli-tuner	179
Raccordement du cordon d’alimentation secteur	179
Mise sous tension de l’ampli-tuner	179
Exécution des opérations de configuration initiale (effacement de tous les réglages mémorisés)	180
Réglage des enceintes	180
Utilisation de la fonction AUTO CALIBRATION	182
Configuration des réglages du réseau de l’ampli-tuner	187
Guide de l’opération affichée à l’écran	192
Opérations de base	194
Lecture d’un appareil source d’entrée	194
Lecture d’un iPod/iPhone	197
Lecture d’un périphérique USB	200
Enregistrement à l’aide de l’ampli-tuner	203
Opérations du tuner	204
Écoute d’une radio FM/AM	204
Préréglage des stations de radio FM/AM (Preset Tuning)	206
Écouter les effets sonores	207
Sélection du champ sonore	207
Utilisation de la fonction d’optimiseur sonore	211
Rétablissement des réglages par défaut des champs sonores	211
Utilisation des fonctions réseau	212
À propos des fonctions réseau de l’ampli-tuner	212
Configuration du serveur	212
Écouter des contenus audio enregistrés sur le serveur	216
Profiter du réseau Sony Entertainment Network (SEN)	218
Utilisation de la fonction PARTY STREAMING	221
Diffusion en continu de musique depuis iTunes avec AirPlay	223
Mise à jour du logiciel	224
Recherche d’un élément à l’aide d’un mot-clé	227
Utilisation des fonctions Bluetooth	228
À propos de la technologie sans fil Bluetooth	228
À propos des fonctions Bluetooth de l’ampli- tuner	228
Écoute de musique sur un périphérique Bluetooth	228
Fonctions « BRAVIA » Sync	231
Qu’est-ce que « BRAVIA » Sync ?	231
Préparation pour « BRAVIA » Sync	232
Exécution des appareils avec la fonction Lecture une touche (Lecture une touche)	232
Écouter le son du téléviseur émis par les enceintes raccordées à l’ampli-tuner (Commande du son du système)	233
Mise hors tension de l’ampli-tuner en même temps que le téléviseur (Mise hors tension du système)	233
Bénéficier du champ sonore optimal pour la scène sélectionnée (Sélection d’une scène)	234
Utilisation de l’ampli- tuner à l’aide de la télécommande du téléviseur (Commande Home Cinéma)	234
Écouter le son du téléviseur émis par les enceintes raccordées à l’ampli-tuner via la prise HDMI OUT A (Audio Return Channel)	235
Commutation des moniteurs qui émettent les signaux vidéo HDMI	235
Autres opérations	236
Passage du son analogique au son numérique et vice versa (INPUT MODE)	236
Utilisation d’autres prises d’entrée vidéo/audio (Input Assign)	236
Utilisation d’un raccordement de bi-amplification	238
Utilisation des fonctions multizones	239
Ajustement des réglages	242
Utilisation du menu Settings	242
Speaker Settings	243
Surround Settings	246
EQ Settings	246
Audio Settings	247
HDMI Settings	248
Network Settings	249
Bluetooth Settings	252
System Settings	253
Utilisation sans raccordement à un téléviseur	254
Utilisation de la télécommande	259
Programmation de la télécommande	259
Effacement de la mémoire de la télécommande	264
Informations complémentaires	264
Précautions	264
Dépannage	266
Spécifications	281

Match case Limit results 1 per page

125

Additional Information

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM

antennas (aerial) as shown below.

Radio stations cannot be tuned in.

• Check that the antennas (aerials) are

connected securely. Adjust the antennas

(aerials) and connect an external antenna

(aerial), if necessary.

• The signal strength of the stations is too

weak with automatic tuning. Use direct

tuning.

• Make sure you set the tuning scale

correctly (when tuning in AM stations

with direct tuning) (page 63).

• No stations have been preset or the preset

stations have been cleared (when tuning

by scanning preset stations is used). Preset

the stations (page 64).

• Press AMP, then press DISPLAY

repeatedly on the remote control so that

the frequency appears on the display

panel.

The sound is distorted.

• Press MASTER VOL – on the remote

control repeatedly.

• Set the “EQ” setting of the iPod/iPhone to

“Off” or “Flat”.

There is no sound from the iPod/

iPhone.

• Disconnect the iPod/iPhone and connect

the iPod/iPhone again.

The iPod/iPhone cannot be charged.

• Check that the receiver is turned on.

• Make sure the iPod/iPhone is connected

firmly.

The iPod/iPhone cannot be operated.

• Check that you have removed the protect

case of the iPod/iPhone.

• Depending on the contents of the iPod/

iPhone, it may take time to start playback.

• Disconnect the iPod/iPhone and connect

the iPod/iPhone again.

• You are using an unsupported iPod/

iPhone. See “Compatible iPod/iPhone

models” (page 56) for the supported

device types.

The ring volume of the iPhone does not

change.

• Adjust the ring volume using the controls

on the iPhone.

Are you using a supported USB

device?

• If you connect an unsupported USB

device, the following problems may occur.

See “Compatible USB devices” (page 59)

for the supported device types.

–

The USB device is not recognized.

–

File or folder names are not displayed

on this receiver.

–

Playback is not possible.

–

The sound skips.

–

There is noise.

–

A distorted sound is output.

Tuner

iPod/iPhone

Receiver

Outdoor FM antenna (aerial)

USB device

continued