TP-Link Archer C2 Archer C2 V1 User Guide 1910010993 - Page 17
Connecting the router
View all TP-Link Archer C2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Archer C2 AC750 Wireless Dual Band Gigabit Router Chapter 2. Connecting the router 2.1 System Requirements Broadband Internet Access Service (DSL/Cable/Ethernet) One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is connected directly to the Ethernet) PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors TCP/IP protocol on each PC Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari 2.2 Installation Environment Requirements Place the router in a well-ventilated place far from any heater or heating vent Avoid direct irradiation of any strong light (such as sunlight) Keep at least 2 inches (5 cm) of clear space around the router Operating Temperature: 0℃~40℃ (32℉~104℉) Operating Humidity: 10%~90%RH, Non-condensing 2.3 Connecting the Router Before installing the router, make sure your PC is connected to the Internet through the broadband service successfully. If there is any problem, please contact your ISP. After that, please install the router according to the following steps. Don't forget to pull out the power plug and keep your hands dry. 1. Power off your modem (if the modem has a backup battery, please remove it too.), and disconnect your existing router if you have one. 2. Connect the Internet port on your router to the modem's LAN port with an Ethernet cable. 3. Connect your computer to one of the Ethernet ports labeled 1~4 on the router with an Ethernet cable. 4. Power on the modem and wait for 2 minutes. 5. Then plug the provided power adapter into the Power jack and the other end to a standard electrical wall socket. Press the Power On/Off button to power on the router. (Before you - 7 -