WestBend 41300 Instruction Manual - Page 6

Know Your Ingredients And Measure Accurately

Page 6 highlights

Over-temp Error: If the display shows "H H H" after the program has been started, it means that the temperature inside of bread pan is too high. You should stop the program and unplug the power cord immediately. Open the lid and let the machine cool down completely before using again. • A small amount of smoke and/or odor may occur upon heating due to the release of manufacturing oils - this is normal. • Some minor expansion/contraction sounds may occur during heating and cooling - this is normal. KNOW YOUR INGREDIENTS AND MEASURE ACCURATELY Although bread making seems very basic, it is a science and the proportions of ingredients are critical. The most important step in using your bread maker is to measure the ingredients precisely and accurately. Read the following information to better understand the importance each ingredient plays in the bread making process. Always make sure the ingredients are fresh. • Measure the liquid ingredients in see-through measuring cups with accurate markings. Place the cup on a flat surface and measure at "Eye Level," not at an angle. All measurements must be accurate. Always use liquids between 80-90°F (27-32°C) to assure optimal yeast activity. • Spoon the dry ingredients into the appropriate measuring cups or spoons, and then level off with table knife. All ingredients measured in measuring spoons and cups must be level, not rounded or heaping. • Never scoop measuring cups into dry ingredients. This will compress the ingredients into the cup and cause the dough to be dry which will result in a short loaf of bread. BREAD FLOUR should be used in your bread maker. It contains more glutenforming proteins than all-purpose flour and will provide well-formed loaves with good structure. Several different brands of bread flour are available. Do not use selfrising or cake flour in your bread maker. WHOLE WHEAT FLOUR can be used in your bread maker using the "WHOLEWHEAT" bread setting. Whole wheat flour contains the entire wheat kernel, including the bran and germ. Therefore, breads made with 100 percent or a high percentage of whole wheat flour will be lower in height and heavier in texture than bread made with bread flour. The "WHOLEWHEAT" setting on your bread maker is programmed to better develop the structure of wheat breads for optimum results. RYE FLOUR can be used in combination with bread flour in the preparation of rye or pumpernickel bread. However, it cannot be used alone as it does not contain enough protein to develop adequate gluten for structure. SUGAR and OTHER SWEETENERS provide food for the yeast, add height and flavor to the bread and give the crust a golden color. Types of sweeteners that can be used include sugar, brown sugar, honey, molasses, maple syrup, corn syrup and fruits, dried or fresh. Do not use artificial sweeteners as a substitute for sugars and other natural sweeteners; artificial sweeteners turn bitter when subjected to baking temperatures, the yeast will not react properly, and poor results will be attained. When measuring sticky sweeteners, such as honey, coat the measuring spoon with vegetable oil before measuring the sweetener. This will allow the sweetener to slide off the spoon without sticking. English - 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76

English - 6
Over-temp Error
: If the display shows “
H H H
” after the program has been started, it
means that the temperature inside of bread pan is too high. You should stop the
program and unplug the power cord immediately. Open the lid and let the machine
cool down completely before using again.
A small amount of smoke and/or odor may occur upon heating due to the
release of manufacturing oils – this is normal.
Some minor expansion/contraction sounds may occur during heating and
cooling – this is normal.
K
NOW
Y
OUR
I
NGREDIENTS AND
M
EASURE
A
CCURATELY
Although bread making seems very basic, it is a science and the proportions of
ingredients are critical. The most important step in using your bread maker is to
measure the ingredients precisely and accurately. Read the following information to
better understand the importance each ingredient plays in the bread making process.
Always make sure the ingredients are fresh.
Measure the liquid ingredients in see-through measuring cups with
accurate markings. Place the cup on a flat surface and measure at
“Eye Level,” not at an angle. All measurements must be accurate.
Always use liquids between 80-90°F (27-32°C) to assure optimal
yeast activity.
Spoon the dry ingredients into the appropriate measuring cups or
spoons, and then level off with table knife. All ingredients measured
in measuring spoons and cups must be level, not rounded or
heaping.
Never scoop measuring cups into dry ingredients. This will
compress the ingredients into the cup and cause the dough to be dry
which will result in a short loaf of bread.
BREAD FLOUR
should be used in your bread maker. It contains more gluten-
forming proteins than all-purpose flour and will provide well-formed loaves with good
structure. Several different brands of bread flour are available.
Do not use self-
rising or cake flour in your bread maker.
WHOLE WHEAT FLOUR
can be used in your bread maker using the
“WHOLEWHEAT” bread setting. Whole wheat flour contains the entire wheat kernel,
including the bran and germ. Therefore, breads made with 100 percent or a high
percentage of whole wheat flour will be lower in height and heavier in texture than
bread made with bread flour. The “WHOLEWHEAT” setting on your bread maker is
programmed to better develop the structure of wheat breads for optimum results.
RYE FLOUR
can be used in combination with bread flour in the preparation of rye or
pumpernickel bread. However, it cannot be used alone as it does not contain
enough protein to develop adequate gluten for structure.
SUGAR and OTHER SWEETENERS
provide food for the yeast, add height and
flavor to the bread and give the crust a golden color. Types of sweeteners that can
be used include sugar, brown sugar, honey, molasses, maple syrup, corn syrup and
fruits, dried or fresh. Do not use artificial sweeteners as a substitute for sugars and
other natural sweeteners; artificial sweeteners turn bitter when subjected to baking
temperatures, the yeast will not react properly, and poor results will be attained.
When measuring sticky sweeteners, such as honey, coat the measuring spoon with
vegetable oil before measuring the sweetener. This will allow the sweetener to slide
off the spoon without sticking.