Yamaha CS6R Owner's Manual - Page 113

Voice Mode PCH PEG (Pitch Envelope Generator) EQ Param (EQ Parameter) PCHíPEG)InitLvl Attack Release---Level Elem +63 +63 +63 -64 EQíParam)LoFreq LoGain HiFreq HiGain Elem 2.0k +12dB 16.0k -12dB s InitLvl (Initial Level) Set the Initial Level. t Settings: -64 ~ 0 ~ +63 s Attack Set the Attack Time. t Settings: -64 ~ 0 ~ +63 s Release Set the Release Time. t Settings: -64 ~ 0 ~ +63 s Level Set the Release Level. t Settings: -64 ~ 0 ~ +63 Pitch Envelope Generator Settings You can set two time (speed) parameters and two level (pitch) parameters controlling the change in pitch from the moment you press a note on the keyboard to the moment you release it. When you press a note on the keyboard, the initial pitch is defined by the InitLvl parameter setting. The pitch then changes from the InitLvl value to the peak pitch within the time set in the Attack parameter. Thereafter, the pitch change is defined by the Release Time/Level settings. Pitch Peak Level Release Level InitLvl + 0 Low Freq Frequency High Freq s LoFreq (Low Frequency) Set the shelving point for the low frequencies. The levels of signals below this frequency will be boosted/attenuated by the amount set in the LoGain parameter. t Settings: 32Hz ~ 2.0kHz s LoGain (Low Gain) Set the amount by which signals below the LoFreq frequency will be boosted/attenuated. t Settings: -64 ~ 0 ~ +63 s HiFreq (High Frequency) Set the shelving point for the high frequencies. The levels of signals above this frequency will be boosted/attenuated by the amount set in the HiGain parameter. t Settings: 500Hz ~ 16.0kHz s HiGain (High Gain) Set the amount by which signals above the HiFreq frequency will be boosted/attenuated. t Settings: -64 ~ 0 ~ +63 0 Attack Time Time Release Time Key off Plug-in Element Native With a Plug-in Board installed, you have native and unique parameters to set up a Board Voice from the Plug-in Board. Plug-in Element EQ (Equalizer) You can set the equalizer settings for the Wave. This is a shelving equalizer with two bands; one for high frequencies and another for low frequencies. PLG-NATIVE (Plug-in Native) Native Part Parameters are displayed. Use the [PAGE] knob to switch to the screen for the desired parameter, then use Knob [C] and Knob [2] to enter the settings. The parameters and number of screens will vary depending on the Plug-in Board. For details about each parameter and its functions, refer to the Owner's Manual or the on-line help that came with your Plug-in Board. 113