Yamaha CS6R Owner's Manual - Page 167
MIDI Other, MIDI GM/XG Receive if a Multi-Part, Plug-in Board has been installed
View all Yamaha CS6R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
s PgmChng (Program Change) Set to enable or disable reception of a Program Change message coming in. With this parameter set to "on," the instrument can receive a Program Change massage coming in, and it can also send a Program Change out to an external MIDI device when you select a Voice or Performance (using a [PROGRAM/PART] key, etc.) on its front panel. t Settings: off (disable), on (enable) MIDI GM/XG Receive (if a Multi-Part Plug-in Board has been installed) Set GM On and XG Reset Receive parameters. This screen is only available if a Multi-Part XG Plug-in Board has been installed. MIDI GM/XG Receive) Sw Sys on InternalPart layer-part Utility Mode s Control Set the MIDI transmit/receive parameters for the CS6x's 14 Sound Control knobs. t Settings: mode1, mode2 mode1: If the knob's Control Change message is not a standard MIDI message, it is transmitted as a Parameter Change message instead. mode2: The [SUSTAIN] knob transmits a Control Change message. MIDI Other Set other MIDI parameters. MIDI Other) In ThruPort Sync SeqCtrl Sys MIDI 1 int on s In (MIDI Input) Select whether to use the MIDI In/Out/Thru connectors or other (future) connectors. At present, you can only select "MIDI." t Settings: MIDI s ThruPort You can connect your synthesizer to a computer via a dedicated serial cable on the TO HOST connector. In which case, MIDI messages received via the TO HOST connector can be passed through the MIDI OUT connector of the synthesizer. Set the port number here. t Settings: 1 ~ 8 s Sw (Receive Switch) Select whether or not to receive GM On and XG Reset messages. The XG Plug-in Board will receive GM On and XG Reset messages if you set this to "on." t Settings: off, on s InternalPart The sound for each of the synthesizer's Parts can be output in the following three ways. when a GM On/XG Reset message is received. Whichever setting you choose, the Parts of the XG Plug-in Board will always be output. t Settings: all part: All Parts of the synthesizer and the Plug-in Board will be output when MIDI messages are received. layer part: Parts which have their Layer Switch parameters set to "on" and all XG Plug-in Board Parts will be output when MIDI messages are received. all off: No Parts of the synthesizer will be output but all XG Plugin Board Parts will be output when MIDI messages are received. By default the Sw parameter is set to "on" and the InternalPart parameter is set to "all off." If you play a song file containing a GM On message, the XG Plug-in Board will be used to play back the song. M.EQ (Voice Master Equalizer) You can assign any of five different Equalizer bands in Voice Mode. The following five screens are available. s Sync To synchronize playback with an external MIDI device, you can use either the synthesizer's internal clock (int) or MIDI clock signals from the external device (midi). Select "int" if you are using the synthesizer as the master, or if you have no other MIDI devices connected to it. Select "MIDI" when slaving your synthesizer to another MIDI Clock source connected to the MIDI IN connector. M.EQ Low M.EQ LowMid (Low-Middle) M.EQ Mid (Middle) M.EQ HighMid (High-Middle) M.EQ High Gain Q (Frequency Characteristic) t Settings: MIDI, int (internal) 0 s SeqCtrl (Sequencer Control) Select whether or not to transmit/receive Song Start, Stop and Continue messages via MIDI. This also switches the transmission of MIDI Clock messages on and off. Freq (Frequency) t Settings: off, on 167