Yamaha PSR-8000 Owner's Manual - Page 115

,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQSong,,QQRecord,,QQing ,,QQ when the first key is played on the keyboard. When FOOT SW 1 or FOOT SW 2 is selected recording will begin when a footswitch connected to the corresponding rear-panel FOOT SWITCH jack is pressed. When AUTO SET is selected, the punch-in and punch-out measures are specified by the IN and OUT LCD dials (i.e. recording begins automatically at the IN measure and ends at the OUT measure). Use the MEASURE SET dials to specify the first playback measure. Be sure to give yourself a few measures "lead-in" prior to the actual punch-in point. • If a measure is specified beyond the last measure which contains data, the last measure which contains data will automatically be selected. q REPLACE Use the RECORD MODE LCD dials to select REPLACE. Use the MEASURE SET LCD dials to specify the measure you want to start recording from. C Return to the main recording display and record Press the OK LCD button to confirm the record mode settings and return to the main MULTI TRACK RECORD display. Or press the CANCEL LCD button to return without making any changes. q PUNCH IN Use the TRACK LCD dials to select a track (or tracks) for PUNCH IN recording. Press the [START/STOP] button to start playback from the specified measure, then record at the punchin point according to the selected PUNCH IN TRIGGER mode (set in the previous step). When the PUNCH IN mode has been selected a REHEARSAL LCD button will appear in the main MULTI TRACK RECORD display. This can be turned "ON" to allow rehearsing the punch-in without actually recording any data. Turn the REHEARSAL function "OFF" when you're ready to do the actual recording. q REPLACE Follow the normal recording procedure described in the previous section. The only difference is that recording will begin from the measure specified in the REC MODE display, and all data from that point to the end of the song will be replaced by the newly-recorded material. • REPLACE or PUNCH IN recording cannot be used on tracks to which rhythm and/or AUTO ACCOMPANIMENT data has been recorded. To re-record such tracks the REC MODE must be set to REPLACE and the MEASURE SET parameter must be set to "1" (this is the normal MULTI TRACK RECORD mode). V Stop recording...If the FIRST KEY ON, FOOT SW 1, or FOOT SW 2 trigger mode was used, stop recording at the punch-out point by pressing the panel [START/STOP] button or the footswitch if a FOOT SW mode was selected. If the AUTO SET trigger was used, recording will stop automatically at the specified OUT measure. • The record PUNCH IN or REPLACE mode remains active after recording, but the measure number reverts to 1. 115