Yamaha PSR-8000 Owner's Manual - Page 94
Pre Listen, Ecute, Loop/one Shot/reverse, Auto Zero, Select, Loop Select, Loop Address, Address, Level
View all Yamaha PSR-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
,,QQ,,QQ,,QQSampli,,QQng ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ PRE LISTEN LCD button to hear how the resampled wave will sound before actually resampling the wave. Press the EXECUTE LCD button to actually resample the selected wave. • Resampling can cause the loop points (see LOOP POINT, below) to shift, resulting unwanted noise. If this happens use the LOOP POINT function to readjust the loop points. 3: LOOP POINT The controls in this display allow you to trim and loop your sampled waves as required. The LOOP/ONE SHOT/REVERSE LCD dials determine whether the wave will be played as a LOOP (i.e. the wave will "loop" as long as a key is held), as a ONE SHOT sample (i.e. the wave will play through once when a key is pressed and then stop), or as a REVERSE one-shot sample (i.e. the wave plays through once in reverse). The AUTO ZERO and LOOP LCD dials are used to trim sample in the ONE SHOT, REVERSE, and LOOP modes. When the ONE SHOT or REVERSE mode is selected, the LOOP SELECT LCD dials select either the START or END address of the wave. When the LOOP mode is selected the LOOP SELECT LCD dials select the START, LOOP START or LOOP END address. The LOOP ADDRESS LCD dials are used to set the selected address as required. The large ADDRESS vw dials vary the selected address in the largest steps (the highest four digits) for coarse adjustment, the medium vw dials vary the selected address in medium steps (the 3rd and 4th digits), and the small vw vary the selected address in the smallest steps (the lowest two digits) for fine adjustment. The LEVEL indicators to the right of each address show the signal level at the current address - the longer the bar, the higher the signal level. This makes it easier to locate zero-level points for noise-free trimming and looping. The AUTO ZERO also aid in locating zerolevel points: when the AUTO ZERO parameter is turned ON, the LOOP ADDRESS LCD dials will automatically only select points in the wave corresponding to, or adjacent to, zero level points. Use the EXTRACT LCD button to automatically remove all data prior to the specified START point and after the END or LOOP END point of your sample. You can play and listen to the wave at any time during the editing process as long as the wave is selected via the monitor LCD button. When all LOOP parameters have been set up as required, press the EXECUTE LCD button to actually edit the selected wave. q ONE SHOT WAVE START q REVERSE WAVE START q LOOP WAVE START LOOP START END END LOOP END 94