Yamaha PSR-8000 Owner's Manual - Page 158
Install the backup batteries, screws removed in step
View all Yamaha PSR-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q 5 • Silver screws. 6 • The notch in the hard disk cover should face towards the rear panel. • Black screws. • The notch on the hard disk cover should be on the opposite side from the connector and cable. BAttach the hard disk unit to the hard disk cover using the four silver screws removed from the hard disk cover in step X. Depending on the type of hard disk drive you plan to install, select holes q or holes w to attach the hard disk drive. * Holes q are used in this illustration. • Be careful not to drop any screws inside the instrument during installation (this can be prevented by keeping the hard disk unit and cover away from the instrument while attaching). If this does happen, be sure to remove the screw(s) from inside the unit before turning the power on. Loose screws inside the instrument can cause improper operation or serious damage. If you are unable to retrieve a dropped screw, consult your Yamaha dealer for advice. N Replace the hard disk cover, and attach with the four black screws removed in step C. Install the backup batteries, set the PSR-8000 right-side up, and connect the power cord to the rear-panel AC INLET jack and an AC outlet. MCheck that the installed hard disk is functioning properly. Turn on the power, go to the DISK display, and execute the FORMAT HARD DISK function. If the format is completed with no trouble, the hard disk is OK. 158