Yamaha PSR-8000 Owner's Manual - Page 152
Installing Options, Optional SIMM Installation
View all Yamaha PSR-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
,QIns,Qtalli,QngO,Qption,Qs ,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q,Q The SIMMs used must meet the following minimum specifications, but this does not guarantee that they will work 1 properly with the PSR-8000. Consult with your nearest Yamaha representative or an authorized distributor listed at the end of this manual before purchasing SIMMs for the PSR-8000. • 16-bit bus compatibility or compliance with JEDEC standards (SIMMs which are only compatible with 32-bit buses can not be used) • 70 nanoseconds or faster access time (note: 60 nanosecond SIMMs are "faster" than 70 nanosecond SIMMs). • No more than 18 memory chips on each SIMM module. • SIMM modules must be no more than 40 mm in height and the thickness of the SIMM should not exceed 8mm on either side when measured from the center of the SIMM. See below. • SIMMs with parity and EDO DRAM modules can also be used. • Use only 4, 8, or 16 megabyte memory modules in pairs of the same type and memory capacity from the same manufacturer: e.g. 4, 8, or 16 megabytes x 2. • Install SIMM memory at your own risk. Yamaha will not be held responsible for any damage or injury resulting from improper installation. 40mm 8mm 8mm Optional SIMM Installation ZBefore installing the SIMMs be sure to save any impor- tant data to disk by using the SAVE TO DISK function described on page 141. Also remove the backup batteries. Turn the PSR-8000 power OFF and unplug the power cord from both the AC wall socket and the instrument's rear panel. Turn the instrument upside down and rest it on a blanket or other soft surface. 152