Yamaha PSR-8000 Owner's Manual - Page 56

,,QQ,,QQ,,QQCustom,,QQVoice,,QQCreato,,QQr ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ E1:WAVEFORM s WAVEFORM (INSTRUMENT for the Drum Kits) ...Use the CATEGORY, VOICE, and WAVEFORM LCD dials to select a waveform for the custom voice: the raw sound on which the voice is based. Waveforms created by the SAMPLING feature (page 88) are also available for selection in the "SAMPLING" CATEGORY. When a waveform which has EG data is selected, the EG COPY LCD button will become available, and pressing it will cause the corresponding EG data to be loaded. When a Drum Kit is selected the WAVEFORM parameter is replaced by the INSTRUMENT parameter, and individual instruments can be selected rather than waveforms. s COARSE TUNE/FINE TUNE ...These parameters adjust the pitch of the voice. COARSE tunes in semitone steps and FINE tunes in 1-cent steps (a cent is 1/ 100th of a semitone). s VOLUME Sets the waveform volume. s KEY ON DELAY Sets the time before the envelope begins after a key is pressed. The higher the value the longer the delay. s PAN ...The PAN LCD dial can be used to position the voice in the center of the stereo sound field, or to the left or right. s NOTE LIMIT (not available for the Drum Kits) ...Specifies the note range over which the voice will sound. The LOW dials set the lowest note in the range and the HIGH dials set the highest note in the range. • When the voice OCTAVE is set to a value other than "0", the range specified by the NOTE LIMIT parameters is shifted by the corresponding amount and some notes may not sound. If this happens check the R1 OCTAVE setting in the FULL MIXING CONSOLE TUNING display. s VELOCITY LIMIT (not available for the Drum Kits) . Sets the maximum velocity range for the voice. The LOW dials set the minumum velocity value and the HIGH dials set the maximum velocity value at which the voice will sound. No sound is produced for velocity values outside the specified range. 56