Yamaha PSR-8000 Owner's Manual - Page 91
Auto Trigger Level, Pre Effect, Importing Waves From Disk, Start, Parameter, Value, Wet/dry, Sampling - hard drive
View all Yamaha PSR-8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQ,,QQSamp,,QQling ,,QQ q AUTO TRIGGER LEVEL For most applications the default AUTO TRIGGER LEVEL setting of "-21.0dB" will provide satisfactory results. If you want to trigger sampling at a lower or higher level, however, use the AUTO TRIGGER LEVEL LCD dials to set the level anywhere from -47.6 to -0.3 dB. Below the "-47.6dB" setting is a "MANUAL" mode in which automatic triggering does not occur. In the MANUAL mode sampling begins immediately the START LCD button is pressed. q PRE EFFECT Press the PRE EFFECT LCD button to go to the PRE EFFECT display. This display page allows you to set up a maximum of three DSP effects to be applied to the source sound as it is sampled. The actual DSPs used and the default settings are: Sample DSP PSR-8000 DSP Block Default Settings DSP1 DSP (MIC) NoiseGate DSP2 DSP (LEAD) Thru DSP3 DSP (RIGHT2) Thru Please note that the DSP blocks are connected in series: i.e. DSP1 → DSP2 → DSP3. To change a PRE EFFECT DSP setup, select the desired DSP via the v and w LCD buttons to the left of the display. Use the TYPE LCD dials to select an effect type, the PARAMETER LCD dials to select any of the parameters available for the selected effect type, and the VALUE LCD dials to change the value of the selected parameter as required. For some effects the WET/DRY parameter can be used to change the balance between the direct ("dry") and effect ("wet") sound as required. Press the EXIT LCD button to return to the SAMPLING/ FILE IMPORT display when done. DSP1 DSP2 DSP3 • Since all PSR-8000 samples are monaural, stereo DSP effects may not produce the expected sound. q Importing Waves From Disk To import previously-saved waveform files or standard WAV or AIFF format files from disk, insert the appropriate disk into the PSR-8000 floppy disk drive (not necessary if the file to be loaded is on the optional internal hard disk), then press the FILE IMPORT LCD button in the SAMPLING/FILE IMPORT display. If the optional hard disk is present, use the DIRECTORY LCD dials to select the floppy disk or hard disk directory containing the file(s) to be loaded. All loadable files within the selected directory will be displayed in the FILE LIST. Use the FILE LIST LCD dials to select the file you want to load, then press the EXECUTE LCD button to load the file. Press the EXIT LCD button to return to the SAMPLING/ FILE IMPORT display when done. After loading the amount of remaining sampling time will be reduced by the size of the loaded data. • If the sample memory is full, or the selected file is larger than the available sample memory, an alert message will appear and loading will not be possible. • A icon between the FILE LIST number and file name indicates a WAV or AIFF format wave file, while a icon indicates a waveform file. 91