Yamaha PSR-K1 Owner's Manual - Page 12

Inserting the SmartMedia card, Setting up the included microphone

Page 12 highlights

Setting Up Inserting the SmartMedia card Setting up the included microphone BEFORE you turn on the power of this instrument, make sure to properly insert the included SmartMedia card in the card slot on the rear panel. With the gold-plated contact side facing down, insert the SmartMedia card firmly but carefully into the card slot, as far as it will go. Be careful not to insert the card upside down or back side in. * This instrument uses SmartMedia™ (3.3V) memory cards. Also included with the instrument is a microphone, letting you enjoy karaoke sing-alongs while playing back the songs, or for singing and playing at the same time. ■ Connecting the microphone Before turning on the power of this instrument, connect the plug of the included microphone to the MIC jack on the rear panel. MIC ROUTPUT L PHONES DC+ IN 1-2V • All data residing in the internal memory of the PSR-K1 such as User songs (songs #101 - 105), a User style (style #136), Registration Memory settings (banks #1 - 8), and panel settings will be lost when turning the power off. Because of this, make sure to insert a SmartMedia card as backup media to the CARD slot on the rear panel before turning the power on and use the card to save your important data. • Be careful not to insert or pull out the SmartMedia card while the power is turned on. Doing so may result in damage to the SmartMedia card and the internal data. Make sure to insert and pull out the SmartMedia card only when the power is off. Make sure to read the section "Using SmartMedia™ cards (memory cards)" on page 11 for more important information on the SmartMedia card. NOTE • To avoid loud pops and sudden noise, turn the volume of the microphone all the way down by turning the [MIC VOLUME] control to the left. Also, set the microphone switch to OFF. ON OFF DYNAMIC • Use the cable holder next to the MIC jack to securely fasten the cable and prevent the plug from being inadvertently pulled out. Cable holder MIC ROUTPUT L PHONES DC+ IN 1-2V 12 PSR-K1 Owner's Manual ■ Moving the Microphone Holder The microphone holder can be installed on either side of the instrument. If you remove the holder, put the spare microphone holder cap in the hole. Microphone holder Microphone holder cap

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100

Setting Up
12
PSR-K1 Owner’s Manual
Inserting the SmartMedia card
BEFORE you turn on the power of this instrument,
make sure to properly insert the included SmartMe-
dia card in the card slot on the rear panel.
With the gold-plated contact side facing down, insert the
SmartMedia card firmly but carefully into the card slot, as far
as it will go.
Be careful not to insert the card upside down or
back side in.
* This instrument uses SmartMedia™ (3.3V) memory cards.
Make sure to read the section “Using SmartMe-
dia™ cards (memory cards)” on page 11 for more
important information on the SmartMedia card.
Setting up the included microphone
Also included with the instrument is a microphone,
letting you enjoy karaoke sing-alongs while playing
back the songs, or for singing and playing at the
same time.
Connecting the microphone
Before turning on the power of this instrument, connect the
plug of the included microphone to the MIC jack on the rear
panel.
Moving the Microphone Holder
The microphone holder can be installed on either side of the
instrument.
If you remove the holder, put the spare micro-
phone holder cap in the hole.
All data residing in the internal memory of the PSR-K1 such
as User songs (songs #101 – 105), a User style (style #136),
Registration Memory settings (banks #1 – 8), and panel set-
tings will be lost when turning the power off. Because of this,
make sure to insert a SmartMedia card as backup media to
the CARD slot on the rear panel before turning the power on
and use the card to save your important data.
Be careful not to insert or pull out the SmartMedia card while
the power is turned on. Doing so may result in damage to the
SmartMedia card and the internal data.
Make sure to insert
and pull out the SmartMedia card only when the power is off.
MIC
OUTPUT
PHONES
DC
+
-
IN 12V
R
L
To avoid loud pops and sudden noise, turn the volume of the micro-
phone all the way down by turning the [MIC VOLUME] control to
the left.
Also, set the microphone switch to OFF.
Use the cable holder next to the MIC jack to securely fasten the
cable and prevent the plug from being inadvertently pulled out.
ON
OFF
DYNAMIC
MIC
OUTPUT
PHONES
DC
+
-
IN 12V
R
L
Cable holder
NOTE
Microphone
holder
Microphone holder cap