Yamaha RXV765 Owner's Manual - Page 24
Connecting the FM and AM antennas, Connecting the power cable, Turning this unit on and off, Press - turns off
UPC - 027108933542
View all Yamaha RXV765 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Connections Connecting the FM and AM antennas An indoor FM antenna and an AM loop antenna are supplied with this unit. Connect these antennas properly to the respective jacks. Indoor FM antenna Outdoor AM antenna Connect a 5 to 10 m (16 to 33 ft) vinyl-covered wire, and extend it outdoors (use the AM loop antenna together with this antenna). AM loop antenna US DOCK COMPONENT VIDEO PR PB Y (BD/DVD) XM HDMI OUT HDMI 1 HDMI 2 HDMI 3 H ANTENNA UNBAL. COMPONENT VIDEO REMOTE PR IN OUT FM GND AM PB VIDEO VIDEO Y MONITOR OUT 12V 0.1A MAX. TRIGGER OUT FRO CENTER Ground (GND terminal) The GND terminal is not for earth grounding. To reduce noises, connect a ground bar or a vinyl-covered wire with a copper plate at its tip, and place it in the moist ground. y • The supplied antennas are normally sensitive enough to obtain good reception. • Position the AM loop antenna away from this unit. • If you cannot get good reception, we recommend that you use an outdoor antenna. For more details, consult the nearest authorized Yamaha dealer or service center. • Always use the AM loop antenna even when the outdoor antenna is connected. Assembling the AM loop antenna Connecting the power cable After all connections are complete, plug the AC power cable of this unit into an AC wall outlet. To the AC wall outlet /PRESENCE Power cable Turning this unit on and off 1 Press AMAIN ZONE ON/OFF (or pPOWER) to turn on this unit. 2 Press AMAIN ZONE ON/OFF (or pPOWER) again to turn off this unit (standby). y • The unit needs a few seconds until ready to play back. • You can also turn on this unit by pressing MSCENE (or iSCENE). • This unit consumes a small amount of electricity even during standby. We recommend disconnecting the power cable from the AC wall outlet. Caution Do not unplug this unit while it is turned on. Doing so may damage this unit or cause the settings of this unit to be saved incorrectly. Connecting the AM loop antenna The wires of the AM loop antenna have no polarity. You can connect either wire to the AM terminal and the other to the GND terminal. Press and hold Insert Release 20 En