Yamaha RXV765 Owner's Manual - Page 77

INTRODUCTION PREPARATION BASIC OPERATION Troubleshooting Problem Cause Remedy External components cannot be controlled by the remote control. The remote control code is not correctly set. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. Set the remote control code correctly using "List of remote control codes" at the end of this manual. Try setting another code of the same manufacturer using "List of remote control codes" at the end of this manual. If this unit does not work when you press kCursor, do the following. When the key does not work during DVD disc menu operation: press the eInput selection keys on the remote control again. When the key does not work during OPTION menu/ SETUP menu operation: press the key applicable for the current menu operation again. See page 63 63 - iPod™ Note • In case of a transmission error without a status message appearing on the front panel display and on the OSD, check the connection of your iPod (see page 19). Problem Cause Remedy See page Loading... This unit is in the middle of recognizing the connection with your iPod. This unit is in the middle of acquiring song lists from your iPod. Connect error There is a problem with the signal path Turn off this unit and reconnect the Yamaha iPod 19 from your iPod to this unit. universal dock to the DOCK jack of this unit. Remove your iPod in the Yamaha iPod universal dock 19 and then place it back in the dock. Unknown iPod The iPod being used is not supported by Connect an iPod supported by this unit. - this unit. iPod Connected Your iPod is properly placed in the Yamaha iPod universal dock. Disconnected Your iPod is removed from the Yamaha iPod universal dock. Unable to play This unit cannot play back the songs Check that the songs currently stored on your iPod - currently stored on your iPod. are playable. ADVANCED OPERATION APPENDIX English 73 En