Yamaha RXV765 Owner's Manual - Page 65

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Controlling Zone2 You can select and control Zone2 by using the control keys on the front panel or on the remote control. The available operations are as follows: • Selecting the input source (AV5-6, AUDIO1-2, V-AUX) of Zone2. • Adjusting the volume of Zone2 (when a Zone2 speaker is connected to the EXTRA SP jack). • Tuning into FM or AM when "TUNER" is selected as the input source of Zone2 (see page 31). • Tuning into XM Satellite Radio when "XM" is selected as the input source of Zone2 (see page 33) (U.S.A. model only). • Tuning into SIRIUS Satellite Radio when "SIRIUS" is selected as the input source of Zone2 (see page 37) (U.S.A. model only). • Playing back music stored on your iPod stationed in a Yamaha iPod universal dock (such as YDS-11 sold separately) connected to the DOCK jack. • You can play back music stored on a Bluetooth component via a Bluetooth wireless audio receiver (sold separately) connected to the DOCK jack (see page 44). Note • You must complete each step while the ZONE2 indicator is flashing on the front panel display. Otherwise, the Zone2 mode is automatically canceled and this unit returns to the normal operation mode. In this case, repeat the Zone2 selection procedure. Controlling Zone2 with the front panel ■ Turning on Zone2 Press CZONE2 ON/OFF to turn on Zone2. ■ Activating the Zone2 operation mode Press EZONE2 CONTROL to control Zone2. The ZONE2 indicator flashes on the front panel display for approximately 10 seconds. Using multi-zone configuration • Select "SIRIUS" as the input source to use the SIRIUS Satellite Radio features in Zone2. For details about the SIRIUS Satellite Radio operations, see "SIRIUS Satellite Radio tuning" on page 37. • Select "DOCK" as the input source to use iPod features in Zone2. For details about the iPod operations, see "Using iPod" on page 42. • Select "DOCK" as the input source to use Bluetooth component features in Zone2. For details about the Bluetooth component operations, see "Using Bluetooth components" on page 44. ■ Setting Zone2 to standby Press CZONE2 ON/OFF to set Zone2 to standby. Controlling Zone2 with the remote control ■ Turning on Zone2 Set bMAIN/ZONE2 to the ZONE2 position, and press pPOWER. ■ Operating Zone2 Set bMAIN/ZONE2 to the ZONE2 position, and press one of the input selection keys to select the desired input source of Zone2. Note • uMUTE and sVOLUME +/- are available to control Zone2 with same procedure as mentioned above. ■ Setting Zone2 to standby Set bMAIN/ZONE2 to the ZONE2 position, and press pPOWER, then set ZONE2 to standby. ZONE Flashes 2 ■ Operating Zone2 Rotate the RINPUT selector to select the desired input source while the ZONE2 indicator on the front panel display is flashing. • When AV5-6, AUDIO1-2 or V-AUX is selected, you can listening to the input source in Zone2. • Select "TUNER" as the input source to use the TUNER features in Zone2. For details about the TUNER operations, see "FM/AM tuning" on page 31. • Select "XM" as the input source to use the XM Satellite Radio features in Zone2. For details about the XM Satellite Radio operations, see "XM Satellite Radio tuning" on page 33. ADDITIONAL INFORMATION APPENDIX English 61 En