Yamaha RXV765 Owner's Manual - Page 72

Troubleshooting Problem No sound is output from a specific speaker. Only the center speaker outputs substantial sound. No sound is heard from the presence speakers. No sound is heard from the surround speakers. No sound is heard from the subwoofer. Cause Remedy The speaker is in malfunction. Check the Speaker indicators on the front panel display. If the corresponding indicator lights up, connect another speaker and check if sound is output. If sound is not output, this unit may be malfunction. The playback component or speakers are Connect the cables properly. If the problem persists, not connected properly. the cables may be defective. Output from that speaker is disabled. Check the Speaker indicators on the front panel display. If the corresponding indicator is turned off, try the following. 1) Change the input source to another one. 2) With the selected sound field program, sound is not output from that speaker. Select another sound field program. 3) "None" may have been selected for that speaker on this unit. Display Speaker Setup in the SETUP menu and set respective parameters to enable output from that speaker (Speaker Setup → 2 Manual Setup → A)Config). The volume of that speaker is set to the minimum in Speaker Setup in the SETUP menu. Display Speaker Setup in the SETUP menu and adjust the volume (2 Manual Setup → B)Level). (If hardly any sound comes from one Set the volume of each speaker to be balanced from channel) "B)Level" in the SETUP menu (Speaker Setup → Speaker output balance is not properly set. 2 Manual Setup → B)Level). Sound may not be output from certain channels depending on the input source or sound field program. Try another sound field program. When a monaural source sound field program is applied, sound of all channels are output from the center speaker for some surround decoders. This unit is in "STRAIGHT" mode. Try another sound field program. Press PSTRAIGHT (or hSTRAIGHT) to exit "STRAIGHT" mode. See page 6, 10 11 6, 24, 27, 55 56 56 27 27 30 This unit is in STRAIGHT mode and a Press PSTRAIGHT (or hSTRAIGHT) to exit 30 monaural source is being played back. STRAIGHT mode. Sound may not be output from certain Try another sound field program. 27 channels depending on input sources or sound field programs. A Dolby Digital or DTS signal is Set "LFE/Bass Out" to "SWFR" or "Both." 55 reproduced while the LFE channel setting (LFE/Bass Out) of the Speaker Setup in the SETUP menu is set to "Front." A 2-channel signal is reproduced while Set "LFE/Bass Out" to "Both." 55 the LFE channel setting (LFE/Bass Out) of the Speaker Setup in the SETUP menu is set to "SWFR" or "Front." The source does not contain LFE or low frequency signals. 68 En