Yamaha RXV765 Owner's Manual - Page 25

INTRODUCTION PREPARATION BASIC OPERATION Optimizing the speaker setting for your listening room (YPAO) This unit has a Yamaha Parametric Room Acoustic Optimizer (YPAO). With the YPAO, this unit automatically adjusts the output characteristics of your speakers based on speaker position, speaker performance, and the acoustic characteristics of the room. We recommend that you first adjust the output characteristics with the YPAO when you use this unit. Notes • Loud test tones may be output during the automatic setup procedure. Do not allow small children to enter the room during the procedure. • To achieve the best results, make sure the room is as quiet as possible while the automatic setup procedure is in progress. If there is too much ambient noise, the results may not be satisfactory. y • You can manually adjust the output characteristics of your speakers with "2 Manual Setup" in the SETUP menu. For details, see page 54. Using Auto Setup 1 Check the following points. Before starting the automatic setup, check the following. • All speakers and subwoofer are connected properly. • Headphones are disconnected from this unit. • The video monitor is connected properly. • This unit and the video monitor are turned on. • This unit is selected as the video input source of the video monitor. • The connected subwoofer is turned on and the volume level is set to about half way (or slightly less). • The crossover frequency controls of the connected subwoofer are set to the maximum. VOLUME CROSSOVER/ HIGH CUT MIN MAX MIN MAX Subwoofer 2 Connect the supplied optimizer microphone to the OPTIMIZER MIC jack on the front panel. OPTIMIZER MIC VIDEO AUX [ [ "MIC ON. View OSD MENU" appears on the front panel display. The following menu screen appears on the video monitor. 1 Auto Setup Extra SP Assign >Zone2 Presence None EQ Type;;;;Natural . Start [ ]/[ ]:Up/Down [ENTER]:Start y • You can bring up the above menu screen from the SETUP menu (see page 54). 3 Place the optimizer microphone at your normal listening position on a flat level surface with the omni-directional microphone heading upward. Optimizer microphone y • It is recommended that you use a tripod or something similar to fix the optimizer microphone at the same height as your ears would be when seated in your listening position. You can fix the optimizer microphone to the tripod with the attaching screw of the tripod. 4 When the speakers are connected to EXTRA SP jacks, press kCursor k repeatedly to select "Extra SP Assign," and then press kCursor l / h to select how to use EXTRA SP jacks from "Zone2," "Presence" or "None." If this unit does not work when you press kCursor, press jSETUP once and then operate this unit. VIDEO AUDIO PORTABLE ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English Optimizer microphone 21 En