Yamaha RXV765 Owner's Manual - Page 35

INTRODUCTION PREPARATION BASIC OPERATION FM/AM tuning The FM/AM tuner of this unit provides the following two modes for tuning. ■ Frequency tuning mode You can tune into a desired FM/AM station by searching or specifying its frequency. ■ Preset tuning mode You can preset the frequencies of FM/AM stations by registering them to specific numbers, and later just select those numbers to tune in. Note • Adjust the FM/AM antennas connected to this unit for the best reception. Tuning into the desired FM/AM station (Frequency tuning mode) 1 Rotate the RINPUT selector (or press eTUNER) to switch the input source to "TUNER." 2 Press IFM (fFM) or IAM (fAM) to select a band. "FM" or "AM" appears on the front panel display according to the band that you have selected. 3 Press JTUNING/CH l / h (or fTUN./CH k / n) to specify the frequency. To adjust the frequency to a higher range, press h (or k). To adjust it to the lower range, press l (or n). The TUNED indicator on the front panel display lights up when the tuner is tuned into a station. The STEREO indicator also lights up if the program being broadcasted is in stereo. STEREO TUNED FM 92.5 MHz The frequency changes in the following manner according to how you press JTUNING/CH l / h (or fTUN./ CH k / n). When you press the key more than 1 second The tuner searches the frequency of a station that is detectable around the current frequency. This is effective when the tuner can receive strong signals without any interference. Once the search starts, release the key. When you press and release the key The tuner increases or decreases the frequency in steps. Use this method when the tuner cannot receive strong signals and stations are skipped during the search. y • You can switch between stereo and monaural for FM broadcast in the OPTION menu (see page 48). 4 To tune in by direct frequency tuning, enter the frequency of the desired station using mNumeric keys on the remote control. Enter only integers. For example, if you want to set the frequency to 88.9 MHz, enter "889" using mNumeric keys. Notes • When you press mNumeric keys during preset tuning, a preset number is selected. Set tuning mode to frequency tuning mode using JTUNING/CH l / h (or fTUN./CH k / n) prior to the operation. • "Wrong Station!" appears on the front panel display when you enter a frequency that is out of receivable range. Make sure that the entered frequency is correct. Registering FM/AM stations and tuning in (Preset tuning mode) You can register up to 40 FM/AM stations (Preset) using the automatic station preset feature or manual station preset feature. Registering stations by automatic station preset The tuner automatically detects FM stations with strong signals and registers up to 40 stations. AM stations cannot be automatically registered. Use manual station preset. 1 Rotate the RINPUT selector (or press eTUNER) to switch the input source to "TUNER." 2 Press rOPTION on the remote control. The OPTION menu screen for setting options of tuner input appears on the front panel display. y • For details on the OPTION menu, see page 46. • The OPTION menu is displayed on the video monitor. 3 Select "Auto Preset," using kCursor k / n and press kENTER. Auto Preset Automatic station preset starts about 5 seconds later from the lowest frequency upwards. y • You can select the preset number at which the preset starts by pressing fPRESET k / n or kCursor k / n on the remote control while "READY" is displayed on the front panel display. • To cancel registration, press kRETURN on the remote control. ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 31 En