Yamaha SH-01 SH-01 Owners Manual - Page 11

Power Supply The SH-01 can be powered with either the power adaptor (PA-3C) or six 1.5V AA size alkaline batteries (LR6) however, we recommend that the power adaptor be used whenever possible. When Using the Power Adaptor 1 Set the SH-01's power switch to the "STANDBY" position, then plug the DC output cable into the DC IN jack on the unit's rear panel. 2 Plug the power adaptor into a convenient wall AC power socket. * When the power adaptor is used, power is delivered from the power adaptor to the device although the device has batteries installed. To keep batteries from leaking we recommend that they be removed from the unit when the power adaptor is used. * Make sure you use only the power adaptor specified for use with the voltage in your particular region. When Using Batteries 1 Set the SH-01's power switch to the "STAND BY" position, then remove the battery cover located on the unit's bottom panel. 2 Insert the new batteries making sure you follow the polarity markings (+/-) as shown in the illustration. 3 Replace the battery cover. * Make sure that only AA size alkaline batteries (LR6) are used in the device. The use of manganese batteries may result an extremely shortened battery life depending upon the type of battery. * When battery power becomes low, the POWER/PEAK lamp will rapidly flash green. As power runs down more seriously, the "BATTERY LOW" message will appear in the display. When this occurs, replace the batteries with a new set of six batteries as soon as possible. * Never mix new batteries with old, mix batteries of different types (mix alkaline with manganese, etc.), or mix batteries from different manufacturers. AA size alkaline batteries (LR6) x6 battery cover 11