Yamaha SH-01 SH-01 Owners Manual - Page 22

Using the SH-01 5 The SH-01 is also equipped with a metronome. Play your guitar along with the metronome to keep the tempo steady. Press and hold the [METRONOME] button until the metronome setup display shown below appears. The metronome immediately starts and sounds in the manner that it is currently setup. The [W/A] button lamp flashes in sync with the metronome (it flashes red on the first beat of every measure and green on the remaining beats). Press the [SELECT] button and flash the item (Tempo, Beat, Mode, Volume) that you want to set, then use the [-]/[+] buttons to set the value or condition. Tempo Beat TEMPO:120 BEAT:4/4 MODE:CONT. VOL:30 Operating Mode Volume • TEMPO 30 - 250 (in 1-step increments) [Factory default: 120] • BEAT 1/4, 2/4, 3/4, 4/4, 6/8 [Factory default: 4/4] • Operating Mode (MODE) .... CONT., PRE. [Factory default: CONT.] This setting determines when the metronome will operate and sound. When set to PRE. (pre-count), the metronome only produces the beat two measures before recording starts to give you the tempo before the song starts. The metronome will not sound while recording is paused. CONT. PRE. While Stopped Sounds No Sound New Recording Pre-count Sounds Sounds During Recording Sounds No Sound • Volume (VOL 0-80 (1-step increments) [Factory Default: 30] You can set the tempo, beat, and volume to whatever you like, but for this demonstration, let's set the MODE to "CONT." After making your settings, press the [ENTER] or [METRONOME] button to return to the main display. * Metronome settings are saved in the unit even when the power is switched OFF. If you want to hear the metronome and you don't need to change any settings, simply press the [METRONOME] button to start the metronome. * The metronome does not function when Mix Recording. 22