1995 Chevrolet Blazer Owner's Manual - Page 92

For a single wiping cycle, turn the band to MIST. Holdthere until the it wipers start, then let go. The wipers will stop after wipe. If you want one more wipes, hold the band on MIST longer. This You can set the wiper speed a long or short delay between wipes. for can be very useful in light rainsnow. Turn the band to or choose the delay time. The closer toLO, the shorter the delay. For steady wiping at low speed, turn the band away from you to theLO position. For high speed wiping, turn the band further, to HI. stop the To wipers ,move the band to the symbol. off Remember that worn or damaged wiper blades may prevent from you seeing well enough to drive safely. avoid damage, be sure to clear ice To and snowfrom the wiper blades before using them. If they're frozen to the windshield, carefully loosen or thaw them. If your bladesdo become worn or damaged, get new blades or blade inserts. Heavy snowor ice can overload your wipers. windshield wiper motor The is protected from overload by a circuit breaker and fuse. If the motor a overheats due to heavy snow, etc., the wiper stop until the motor will cools. Although the circuit is protected electrical overload, overload to from due heavy snow, etc. may cause wiper linkage damage. Always clear ice and heavy snow from the windshield before using your windshield wipers. Windshield Washer At the top the of multifunction lever there's a paddle marked with the windshield washer symbol andPUSH. To spray washer fluidon the windshield, push the paddle. The wipers will clear the window and then either or return to your stop preset speed. Driving withoutwasher fluid can be dangerous. A bad mud splashcan block your vision.You could hit another vehicle go off the road. Check your or washer fluid level often. 2-40