2010 Chrysler Town & Country Owner Manual - Page 170
2010 Chrysler Town & Country Manual
Page 170 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 169 2. Intermittent, Low and High Speed Wipers Use the intermittent wipers when weather conditions make a single wiping cycle, with a variable pause between cycles, desirable. Rotate the end of the multifunction lever to the first detent position, then turn the end of the multifunction lever to select the desired delay interval. The delay can be regulated from approximately two seconds, to a maximum of 20 seconds between cycles. The time delay will be doubled if the vehicle speed is less than 10 mph (16 km/h). Low-speed is achieved by rotating the multifunction lever past the intermittent settings, to the first detent. High-speed is achieved by rotating the multifunction lever past the intermittent settings, to the second detent. 3. Rear Wiper and Washer Rotating the rotary ring to the first detent activates the rear intermittent wipers. To activate the washers, rotate the rotary ring fully forward and the washers will spray until the ring is released, and then resume the intermittent interval. NOTE: Rear window wipers function in the intermittent wiper speed only. 3 WARNING! Sudden loss of visibility through the windshield could lead to an accident. You might not see other vehicles or other obstacles. To avoid sudden icing of the windshield during freezing weather, warm the windshield with defroster before and during windshield washer use.