2010 Chrysler Town & Country Owner Manual - Page 246
2010 Chrysler Town & Country Manual
Page 246 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 245 means the engine oil change interval may fluctuate 25. Odometer dependent upon your personal driving style. The odometer shows the total distance the vehicle has been driven. Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN U.S. Federal regulations require that upon transfer of position. To turn off the message temporarily, press and vehicle ownership, the seller certify to the purchaser the release the Trip / Odometer Display reset button on the correct mileage that the vehicle has been driven. If your instrument cluster. To reset the oil change indicator odometer needs to be repaired or serviced, the repair system (after performing the scheduled maintenance), technician should leave the odometer reading the same perform the following steps. as it was before the repair or service. If s/he cannot do so, then the odometer must be set at zero, and a sticker must 1. Turn the ignition switch to the ON position (do not be placed in the door jamb stating what the mileage was start the engine). before the repair or service. It is a good idea for you to 2. Fully depress the accelerator pedal, slowly, three times make a record of the odometer reading before the repair/ service, so that you can be sure that it is properly reset, or within 10 seconds. that the door jamb sticker is accurate if the odometer 3. Turn the ignition switch to the OFF/LOCK position. must be reset at zero. NOTE: If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps. 4