2010 Chrysler Town & Country Owner Manual - Page 97

96 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE WARNING! An incorrectly anchored tether strap could lead to increased head motion and possible injury to the child. Use only the anchor positions directly behind the child seat to secure a child restraint top tether strap. then allow the belt to retract into the retractor. For additional information on ALR, refer to "Automatic Locking Mode". To install a child restraint, first, pull enough of the seat belt webbing from the retractor to route it through the belt path of the child restraint and slide the latch plate into the buckle. Next, extract all the seat belt webbing out of the retractor and then allow the belt to retract into the Installing the Child Restraint Using the Vehicle retractor. Finally, pull on any excess webbing to tighten Seat Belts the lap portion around the child restraint. Any seat belt The seat belts in the passenger seating positions are system will loosen with time, so check the belt occasionequipped with either an Automatic Locking Retractor ally, and pull it tight if necessary. (ALR) or a cinching latch plate or both. Both types of seat belts are designed to keep the lap portion of the seat belt Once you have completed securing the child restraint tight around the child restraint so that it is not necessary with the seat belt secure the top tether strap. Refer to to use a locking clip. The ALR will make a ratcheting ЉInstalling the Top Tether StrapЉ for instructions. noise if you extract the entire belt from the retractor and