2010 Chrysler Town & Country Owner Manual - Page 197

196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Using HomeLink௡ To operate, press and release the programmed HomeLink௡ button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The handheld transmitter of the device may also be used at any time. Gate Operator/Canadian Programming Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink௡ to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner. Reprogramming a Single HomeLink௡ Button It may be helpful to unplug the device during the cycling To reprogram a channel that has been previously trained, process to prevent possible overheating of the garage follow these steps: door or gate motor. If you are having difficulties programming a garage door opener or a gate operator, replace "Programming 2. Press and hold the desired HomeLink௡ button until HomeLink௡" Step 3, with the following: the indicator light begins to flash after 20 seconds. Do not release the button. 3. Continue to press and hold the HomeLink௡ button, while you press and release ("cycle"), your handheld 3. Without releasing the button, proceed with Programtransmitter every two seconds until HomeLink௡ has ming HomeLink௡ Step 2 and follow all remaining steps. 1. Turn the ignition switch to the ON/RUN position.