2010 Chrysler Town & Country Owner Manual - Page 18

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 lamps and/or turn signals will flash and Vehicle Security Light will flash repeatedly and the horn will sound. For an additional 15 minutes, only the headlights, park lamps and/or turn signals and Vehicle Security Light will flash. The engine will run only if a valid key is used to start the vehicle. Rearming Of The System The Vehicle Security Alarm will rearm itself after the 15 additional minutes of headlights and Vehicle Security Light flashing, if the Vehicle Security Alarm has not been disabled. If the condition which initiated the alarm is still present, the Vehicle Security Alarm will ignore that condition and monitor the remaining doors and ignition. locked and closed, the Vehicle Security Light in the instrument cluster will flash rapidly to signal that the Vehicle Security Alarm is arming. The Vehicle Security Light in the instrument panel cluster will flash rapidly for about 16 seconds to indicate that the alarm is being set. After the alarm is set, the Vehicle Security Light will flash at a slower rate to indicate that the Vehicle Security Alarm is armed. NOTE: If the Vehicle Security Light stays on continuously during vehicle operation, have the system checked by your authorized dealer. Disarm The System Either press the UNLOCK button on the RKE transmitter or insert a valid ignition key into the ignition switch. 2 Arming The System Remove the key from the ignition switch and either press NOTE: a power door lock switch while the driver or passenger • The driver's door key cylinder and the liftgate button door is open, or press the LOCK button on the Remote on the RKE transmitter cannot arm or disarm the Keyless Entry (RKE) transmitter. After all the doors are Vehicle Security Alarm.