2010 Chrysler Town & Country Owner Manual - Page 30
2010 Chrysler Town & Country Manual
Page 30 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 equipped). Then, prior to the end of the 15-minute cycle, • The hood is opened insert the Key Fob into the ignition switch and turn the • The hazard switch is pressed switch to the ON position. • The shift lever is moved out of PARK NOTE: • The ignition switch must be in the ON position in • The engine is allowed to run for the entire 15-minute order to drive the vehicle. cycle • For vehicles equipped with the Electronic Vehicle Information Center (EVIC), the message "Insert Key/ Turn to ON" will flash in the EVIC until you insert the Key Fob. Once inserted, the message "Turn to ON" will flash in the EVIC until you turn the Key Fob to ON. To Turn Off the Engine While in Remote Start Mode Press and release the REMOTE START button one time or allow the engine to run for the entire 15 minute cycle. 2 NOTE: To avoid unintentional shutdowns while in the Remote Start Mode, the system will not allow the Remote Cancel Remote Start Start button to shutdown the engine for two seconds after Remote Starting will also cancel if any of the following receiving a valid Remote Start request. occur: When to Reset Remote Start • The engine stalls or engine speed exceeds 2500 rpm The vehicle can be started remotely up to a maximum of two times. The vehicle is also allowed a maximum of one • Any engine warning lights come on