2010 Chrysler Town & Country Owner Manual - Page 330

STARTING AND OPERATING 329 CAUTION! To prevent damage to the starter, DO NOT crank the engine for more than 15-second intervals at one time. Wait 10 to 15 seconds before trying again. After Starting The idle speed will automatically decrease as the engine warms up. ENGINE BLOCK HEATER - IF EQUIPPED The engine block heater warms the engine, and permits If the engine has been flooded, it may start to run, but not quicker starts in cold weather. Connect the electrical cord have enough power to continue running when the key to a standard 110-115 Volt AC electrical outlet with a fob is released. If this occurs, continue cranking with the grounded, three-wire extension cord. accelerator pedal pushed all the way to the floor. Release The engine block heater cord is routed under the hood on the accelerator pedal and the key fob once the engine is the driver's side of the vehicle. It has a removable cap running smoothly. that is located on the driver side of the Integrated Power If the engine shows no sign of starting after two 15- Module. second intervals of cranking with the accelerator pedal held to the floor, the "Normal Starting" procedure should be repeated. 5 WARNING! Remember to disconnect the electrical cord before driving. Damage to the 110-115 volt electrical cord could cause electrocution.