2010 Chrysler Town & Country Owner Manual - Page 463

462 MAINTAINING YOUR VEHICLE CAUTION! Using a transmission fluid other than the manufacturer's recommended fluid may cause deterioration in transmission shift quality and/or torque converter shudder. Using a transmission fluid other than the manufacturer's recommended fluid will result in more frequent fluid and filter changes. Refer to "Fluids, Lubricants, and Genuine Parts" in "Maintaining Your Vehicle" for further information. 2. The engine should be running at curb idle speed for a minimum of 60 seconds. 3. Fully apply the parking brake. 4. Place the shift lever momentarily into each gear position, ending with the shift lever in PARK. Wipe the area around the dipstick clean to eliminate the possibility of dirt entering the transmission. 5. Remove the dipstick and determine if the fluid is hot or warm. Hot fluid is approximately 180°F (82°C), which is the normal operating temperature after the vehicle has Fluid Level Check (3.3L Engine with Four-Speed been driven at least 15 miles (24 km). The fluid cannot be Automatic Transmission) - If Equipped comfortably held between the fingertips. Cold is when The dipstick is located just behind the radiator on the the fluid is below 80°F (27°C). lower right side. 6. Wipe the dipstick clean and reinsert until seated. To properly check the automatic transmission fluid level, Remove the dipstick and note reading. the following procedure must be used: 1. The vehicle must be on level ground.